USCG Engineering General Subjects – Question Bank Book 11 (BK11) — page 29
3080 questions with correct answers from the official USCG question bank (2008 edition), book 11 (Engine – USCG question bank, 2008 edition, Engine officers). Pass mark 70%. Click a question to see its answer.
Take the full practice test →Free USCG practice test with the real pass mark, no sign-up- 2801.If you have a duplex double acting reciprocating pump making 170 strokes/minute, with a 6" diameter cylinder, a 5" stroke and operating with 97% volumetric efficiency, what is the capacity of this pump?
- 2802.Which of the following is the probable cause for a motor driven, low pressure, reciprocating air compressor to repeatedly trip the circuit breaker upon starting?
- 2803.If you have a simplex single acting reciprocating pump making 130 strokes/minute, with a 6" diameter cylinder, a 14" stroke and operating with 93% volumetric efficiency, what is the capacity of this pump?
- 2804.In refrigeration systems with multiple evaporators, the metering of refrigerant to each refrigerated space is accomplished by __________.
- 2805.The high pressure cut-out switch used on centrifugal low pressure refrigeration units using R-123 would be set to shut off the compressor at approximately ________.
- 2806.When welding or burning with an oxy-acetylene torch, __________.
- 2807.If you have a duplex double acting reciprocating pump making 140 strokes/minute, with a 4" diameter cylinder, a 7" stroke and operating with 85% volumetric efficiency, what is the capacity of this pump?
- 2808.If a bilge pump is able to develop some vacuum, but is unable to sufficiently pump out the bilges, you would check for __________.
- 2809.If you have a duplex double acting reciprocating pump making 160 strokes/minute, with a 4" diameter cylinder, a 10" stroke and operating with 75% volumetric efficiency, what is the capacity of this pump?
- 2810.The difference between the setpoint and the measured parameter in an automatic flow controller is called:
- 2811.The range of values around a setpoint of a measured variable where "no action" occurs in an automatic flow controller is called:
- 2812.In addition to pressure, most refrigerant compound gages are also provided with a scale indicating __________.
- 2813.If you have a simplex single acting reciprocating pump making 130 strokes/minute, with a 5" diameter cylinder, a 13" stroke and operating with 93% volumetric efficiency, what is the capacity of this pump?
- 2814.In an automatic flow controller, the factor by which the magnitude of the flow error signal has been increased to drive the final valve controller is referred to as:
- 2815.In a proportional controller, the term "offset" refers to the difference between the:
- 2816.The return signal from a valve as sensed by an automatic flow controller that is proportional to the actual valve position is referred to as:
- 2817.The difference between the set point in an automatic controller and the steady-state value of the measured parameter is called:
- 2818.Which of the following changes in pump operating parameters will lead to pump cavitation in a centrifugal pump that is operating in an open system?
- 2819.If you have a duplex double acting reciprocating pump making 110 strokes/minute, with a 3" diameter cylinder, a 5" stroke and operating with 97% volumetric efficiency, what is the capacity of this pump?
- 2820.Which of the following statements is correct concerning a halide torch leak detector?
- 2821.If a reciprocating air compressor has a knock occurring in frequency with its operating RPM, the cause is probably __________.
- 2822.If you have a simplex single acting reciprocating pump making 130 strokes/minute, with a 4" diameter cylinder, a 12" stroke and operating with 93% volumetric efficiency, what is the capacity of this pump?
- 2823.In a direct expansion condensing unit type refrigeration system, an externally equalized thermal expansion valve will respond to __________. I. A change in temperature of the evaporator coil II. pressure surges at the compressor suction
- 2824.While at sea, the flash type evaporator is discharging the output to the boiler water reserve feed tanks. If it becomes necessary to reduce the evaporator feed water temperature to below 165°F, you should _______.
- 2825.An engine spare parts storeroom is at a temperature of 70 degrees Fahrenheit and contains a storage bottle of refrigerant R-22. What would be the approximate gage pressure inside this bottle?
- 2826.One of the main functions of wearing rings, as used in a centrifugal pumps, is to __________.
- 2827.If you have a duplex single acting reciprocating pump making 130 strokes/minute, with a 5" diameter cylinder, a 11" stroke and operating with 93% volumetric efficiency, what is the capacity of this pump?
- 2828.Which of the listed conditions would cause the thermal expansion valve to open in a refrigeration system?
- 2829.If you have a duplex double acting reciprocating pump making 120 strokes/minute, with a 5" diameter cylinder, a 6" stroke and operating with 89% volumetric efficiency, what is the capacity of this pump?
- 2830.The absolute pressure maintained in the shell of the salt water feed heater on most flash evaporators used on steam propelled vessels is __________.
- 2831.If you have a duplex double acting reciprocating pump making 140 strokes/minute, with a 5" diameter cylinder, a 7" stroke and operating with 94% volumetric efficiency, what is the capacity of this pump?
- 2832.Which of the locations listed would be considered as the most common place to install a dryer in a refrigeration system?
- 2833.On modern tankers with separate pumprooms, which of the following is used to minimize cargo pump shaft leakage?
- 2834.When there is no movement of the rams of an electro-hydraulic steering gear system, the tilting box of the axial piston hydraulic pump is __________.
- 2835.A "P" type trap and drain is used for sanitary system piping rather than an "S" type trap, whenever __________.
- 2836.In a typical refrigeration system, refrigerant leaving the receiver will then flow to the __________.
- 2837.If a bolt or stud were to break off flush at the surface of a flange or block, which of the following procedures would offer the best chance of success for its removal?
- 2838.Which of the following statements best describes the term 'base' in reference to the classification of lubricating grease?
- 2839.Which of the gasket types listed is typically used on high pressure steam flange joints?
- 2840.When air compressors are arranged for automatic operation, the cylinders can be unloaded during starting by __________.
- 2841.If your vessel burns 8 tons of fuel per hour at 15 knots, how many tons per hour will it burn at 22 knots?
- 2842.If you have a duplex single acting reciprocating pump making 130 strokes/minute, with a 5" diameter cylinder, a 13" stroke and operating with 93% volumetric efficiency, what is the capacity of this pump?
- 2843.Which of the following forms of heat can be removed from the refrigerant in the condenser of a refrigeration system?
- 2844.If you have a duplex double acting reciprocating pump making 140 strokes/minute, with a 6" diameter cylinder, a 10" stroke and operating with 94% volumetric efficiency, what is the capacity of this pump?
- 2845.In a refrigeration system, where multiple evaporators are operating at different temperatures, and serviced by a single compressor and condenser, the control of individual coil temperatures should be carried out by adjustment of the __________.
- 2846.The flame screens installed on tank vents that may contain combustable gases, are designed to prevent explosions by _______.
- 2847.When renewing a portion of damaged hull plating with a new insert plate, which of the listed guidelines should be followed?
- 2848.When renewing spiral packing in a centrifugal pump stuffing box, after the packing is firmly seated, the packing gland nuts should be __________.
- 2849.If you have a duplex single acting reciprocating pump making 140 strokes/minute, with a 4" diameter cylinder, a 7" stroke and operating with 85% volumetric efficiency, what is the capacity of this pump?
- 2850.Which of the components listed is required for the processing of bilge slops for overboard discharge?
- 2851.If you have a duplex single acting reciprocating pump making 130 strokes/minute, with a 6" diameter cylinder, a 14" stroke and operating with 93% volumetric efficiency, what is the capacity of this pump?
- 2852.Machinery with ball bearings designed to be filled with grease should have the relief plug temporarily removed while grease is being added. This plug should remain out until the machinery has been operated and sufficiently warmed up to ensure that _____
- 2853.After using a pipe cutter to cut a piece of pipe, the inside edge of the pipe should be __________.
- 2854.Excessively tight drive belts installed between a motor and a refrigeration compressor pulley may cause __________.
- 2855.The thermal bulb for a thermal expansion valve used in a refrigeration system is usually charged with __________.
- 2856.Under standard atmospheric conditions, air at a higher temperature can __________.
- 2857.Under standard atmospheric conditions, which of the following is true concerning the characteristics of air?
- 2858.Which of the following is true when comparing the different "class of fit" for machine threads on bolts and nuts?
- 2859.The purpose of wearing rings as found in large centrifugal pumps is to __________.
- 2860.Two individual centrifugal pump impellers of the same diameter, width, and rotating speed are to be compared, one is cast with straight vanes, the other with curved vanes. Which of the following statements is correct?
- 2861.The primary purpose of the liquid line strainer used in a refrigeration system is to prevent dirt and scale from entering the __________.
- 2862.Which of the following forms of energy is released through the process of fuel combustion?
- 2863.If you have a simplex single acting reciprocating pump making 170 strokes/minute, with a 6" diameter cylinder, a 5" stroke and operating with 97% volumetric efficiency, what is the capacity of this pump?
- 2864.At the beginning of a cool down period for a multibox refrigeration system, the operating conditions of the system would require the flow rate of refrigerant circulating in the system to _________.
- 2865.Bilge suction lines led through tanks, without using a pipe tunnel, must be __________.
- 2866.Which of the following methods is normally used to control the individual room temperature with an air conditioning system using a chilled water circulation system?
- 2867.Which of the statements best describes the process of heat transfer by conduction?
- 2868.Strainers are commonly used in hydraulic systems to __________.
- 2869.Cylindrical driers installed in halocarbon refrigerant systems should be arranged __________.
- 2870.As the speed of an oil lubricated ball bearing increases, fluid friction, due to churning, generates heat. This condition may be be avoided by __________.
- 2871.If you have a simplex single acting reciprocating pump making 150 strokes/minute, with a 3" diameter cylinder, a 11" stroke and operating with 95% volumetric efficiency, what is the capacity of this pump?
- 2872.According to Coast Guard Regulations (33 CFR Part 159), which of the listed types of Marine Sanitation Devices (MSD) is designed to hold sewage on board in special tanks to be pumped out at shoreside facilities when available?
- 2873.Which of the nondestructive testing methods listed, is most often used to accurately detect external defects in welded metals?
- 2874.Zinc plates commonly found in refrigeration systems are located in the __________.
- 2875.If the flame of a Halide leak detecting torch burns yellow, which of the problems listed is indicated?
- 2876.Which practices should be followed at all times when using an electric bench grinding machine?
- 2877.Which of the following statements best describes an oil lubricated stern tube bearing installation?
- 2878.A totally white or yellow colored flame produced by a Halide torch being used to test for refrigerant leaks indicates __________.
- 2879.Hydraulically, servo-operated, automatic, change over valves, utilized in a two ram hydraulic steering gear, serve to __________.
- 2880.The presence of gas in the liquid line of a refrigeration system is undesirable and can be eliminated by __________.
- 2881.Sludge may form in the lubricating oil crankcase of a reciprocating air conditioning compressor as a result of __________.
- 2882.If you have a duplex single acting reciprocating pump making 130 strokes/minute, with a 3" diameter cylinder, a 10" stroke and operating with 93% volumetric efficiency, what is the capacity of this pump?
- 2883.The sudden reduction of pressure occurring within the crankcase of a refrigeration compressor during starting causes the __________.
- 2884.All refrigerant recovered from small appliances must be __________.
- 2885.Air conditioning duct-work begins at the large mixing chamber called the __________.
- 2886.Foot valves are primarily designed to __________.
- 2887.If a substantial difference is maintained between the refrigerant temperature and the box air temperature within the refrigerated compartment, this may result in __________.
- 2888.If you have a simplex single acting reciprocating pump making 270 strokes/minute, with a 4" diameter cylinder, a 6" stroke and operating with 75% volumetric efficiency, what is the capacity of this pump?
- 2889.When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should __________.
- 2890.Which of the fluids listed is normally used to condense the primary refrigerant in a shipboard central air conditioning system?
- 2891.To add refrigerant to the high side of an air conditioning system, you should close the king valve and introduce the refrigerant through the __________.
- 2892.In a small appliance using HFC-134a you would expect to see the greatest temperature drop across the __________.
- 2893.When air contains some moisture, but is not saturated, the dew point temperature is __________.
- 2894.Regarding heat transfer principles, which of the following is true?
- 2895.If you have a simplex single acting reciprocating pump making 150 strokes/minute, with a 6" diameter cylinder, a 14" stroke and operating with 95% volumetric efficiency, what is the capacity of this pump?
- 2896.Copper piping has been used in refrigeration systems because __________.
- 2897.If you have a duplex single acting reciprocating pump making 140 strokes/minute, with a 3" diameter cylinder, a 12" stroke and operating with 94% volumetric efficiency, what is the capacity of this pump?
- 2898.If the people in an air conditioned room complain of being too cool, the trouble might be that the __________.
- 2899.Gate valves should not be used for throttling as __________.
- 2900.When pumping down an air conditioning system to test the low pressure cutout switch, you should __________.