USCG Motor Plants and Auxiliary Boilers – Question Bank Book 14 (BK14) — page 9
1960 questions with correct answers from the official USCG question bank (2008 edition), book 14 (Engine – USCG question bank, 2008 edition, Engine officers). Pass mark 70%. Click a question to see its answer.
Take the full practice test →Free USCG practice test with the real pass mark, no sign-up- 801.White smoke exhausting from a diesel engine can result from __________.
- 802.The reason some two-stroke/cycle, diesel engine piston rings are pinned to prevent rotation, is __________.
- 803.A distorted spray pattern from a fuel injector can cause __________.
- 804.Black smoke exhausting from an operating diesel engine can be caused by __________.
- 805.A six cylinder, single acting, four-stroke/cycle diesel engine has a bore of 10 1/2 inches, and a stroke of one foot, producing 75 HP per cylinder at 720 RPM. What is the mean effective pressure in the engine cylinders for the stated conditions?
- 806.A device which functions to bring a diesel engine to a full stop to protect it from damage is known as a/an __________.
- 807.If control air systems are supplied from starting air receivers, the capacity of the receivers should be sufficient __________.
- 808.Which of the following statements represents the advantage of a pre-combustion chamber used in an auxiliary diesel engine?
- 809.When would the available energy of the exhaust gases of a two-stroke/cycle diesel engine be insufficient to drive an exhaust gas turbocharger, resulting in the incorrect amount of air for combustion?
- 810.Oil control rings are designed with slotted holes to __________.
- 811.What is the average piston speed of a five cylinder low- speed engine with a bore of 29.5 inches (75 cm), a stroke of 63 inches (160 cm), and a rated speed of 123 RPM?
- 812.Broken intake valve springs on one cylinder of a diesel engine can cause the engine to __________.
- 813.One advantage obtained from the use of a pre-combustion chamber in a diesel engine is __________.
- 814.Electrically operated safety devices on auxiliary diesel engines function to stop the engine by __________.
- 815.The compression ratio of a diesel engine refers to the ratio between the __________.
- 816.A pilot-operated, main air starting valve begins leaking in one cylinder while the engine is operating. This malfunction is indicated by __________.
- 817.White smoke exhausting from an operating diesel engine may indicate __________.
- 818.When the opening pressure of a diesel fuel injector is greater than that specified by the engine manufacturer, the __________.
- 819.The metal edge type filters used in diesel engine fuel oil and lube oil systems are normally cleaned in place by __________.
- 820.If the main engine of an unattended engine room shuts down automatically, it will be indicated by an alarm __________.
- 821.Increasing the exhaust valve tappet clearance of a diesel engine will result in the exhaust valve opening __________.
- 822.White smoke issuing from the exhaust of an auxiliary diesel engine could mean __________.
- 823.Pre-combustion chambers differ from turbulence chambers in that pre-combustion chambers __________.
- 824.Oil control rings function to __________.
- 825.What may be used to protect starting air mains against explosions arising from improperly functioning starting valves?
- 826.In diesel engines, the four basic events (intake, compression, power and exhaust) are performed once in __________.
- 827.Engine protection by means of an alarm or shutdown control can be obtained with devices that are sensitive to __________.
- 828.If a diesel engine fails to start, one of the likely causes is __________.
- 829.The main purpose of the piston oil scraper rings is to __________.
- 830.What is commonly used to create turbulence in a diesel engine combustion system?
- 831.What causes diesel fuel to be ignited in the cylinder of an operating diesel engine?
- 832.If a hydraulic starting motor turns, but the diesel engine does not, the most likely cause is __________.
- 833.The highest pressure in a diesel engine cylinder normally occurs __________.
- 834.How many power strokes per crankshaft revolution are there in an eight cylinder, two-stroke/cycle diesel engine?
- 835.A smoking exhaust from an operating diesel engine could be caused by __________.
- 836.The purpose of compressing the air within the cylinder of a diesel engine is to __________.
- 837.The primary purpose of oil control rings on a diesel engine piston is to __________.
- 838.Which of the fuel nozzles listed requires the LEAST maintenance?
- 839.Diesel engine lube oil diluted with fuel oil is indicated by __________.
- 840.Which device will normally shut down a diesel engine after it exceeds its maximum speed setting?
- 841.Opposed piston diesel engines are classified as __________.
- 842.The most important factor in engine performance is the actual power output at the end of the crankshaft available for doing work. This is known as __________.
- 843.In describing basic diesel engine operation, the term 'event' refers to __________.
- 844.Oil control rings used in two-stroke/cycle diesel engines are located near the bottom of the piston skirt in order to __________.
- 845.The spray holes in diesel engine fuel valves should be cleaned using carbon solvent and __________.
- 846.When excessive fuel dilution is noted in the lube oil, the oil should be __________.
- 847.In an operating diesel engine, which of the following conditions is an indication of a leaking air starting valve?
- 848.Bluish smoke in the exhaust of an operating diesel engine can be caused by __________.
- 849.Which of the listed cylinder liner surface conditions indicates proper lubrication?
- 850.To function properly, oil control rings used on a diesel engine piston must distribute sufficient oil to all parts of the cylinder wall and must also __________.
- 851.The dripping of fuel from an injector nozzle after injection terminates, often results in __________.
- 852.When fuel oil has seriously contaminated a diesel engine lubricating oil, you should __________.
- 853.A diesel engine may fail to start due to __________.
- 854.A diesel engine electric starting motor is operated under a no-load condition. Continuing to operate the motor unloaded will __________.
- 855.An over speed trip stops a diesel engine when the engine __________.
- 856.Where engine bores exceed 230 mm, a bursting disc or flame arrestor is fitted __________.
- 857.What is the average piston speed of a 4 cycle diesel engine with a 12 inch stroke, operating at 900 RPM?
- 858.When the cold tappet clearance is less than that specified by the engine manufacturer, the diesel engine valves will __________.
- 859.In order to keep excess oil from the intake ports in two-stroke/cycle diesel engines, __________.
- 860.If it becomes necessary to clean the spray holes in a diesel engine fuel injector, you should use a suitable size piano wire and __________.
- 861.A decrease in the flash point of diesel engine lube oil indicates the lube oil has become __________.
- 862.The ratio of the brake horsepower to the indicated horsepower of a diesel engine is its __________.
- 863.The main operating characteristic of diesel engines which distinguishes them from other internal combustion engines is the __________.
- 864.The firing order of an in-line, four-stroke/cycle, six cylinder, auxiliary diesel engine is 1-5-3-6-2-4. When the #1 cylinder is firing at top dead center, the #3 piston is __________.
- 865.A diesel engine is warmed up and white vapor is noted in the exhaust, this could indicate __________.
- 866.Slots are provided in a diesel engine piston oil scraper ring to __________.
- 867.A broken pintle in a fuel injector usually causes __________.
- 868.If a sample of engine lube oil indicates excessive fuel dilution, the lube oil should be __________.
- 869.Diesel engine operating conditions are indicated by the color of the exhaust smoke. Blue smoke can indicate __________.
- 870.Oil accumulating in the exhaust piping or manifold of a diesel engine can be caused by __________.
- 871.If the compression ratio is increased on any diesel engine, __________.
- 872.In diesel engines, the four basic events (intake, compression, power, and exhaust) are performed once in __________.
- 873.A practical way of checking for excessive fuel injection in one cylinder of an operating diesel engine is to __________.
- 874.A 'detergent-type' lube oil, used in a diesel engine, should be replaced when __________.
- 875.Diesel engine exhaust valve springs are under compression when the valves are __________.
- 876.What determines the number of events occurring in a cycle of operation in an internal combustion engine?
- 877.A diesel engine may fail to start when being cranked, due to __________.
- 878.The function of the piston compression rings used in a diesel engine is to __________.
- 879.Which of the following problems could cause misalignment between the needle valve and nozzle in a fuel injection nozzle?
- 880.Which of the following test indicators should be considered a determining factor as to whether or not a diesel generator's lube oil should be drained and renewed?
- 881.If a diesel engine hydraulic starting motor fails to disengage from the engine, your FIRST check should be the __________.
- 882.Which of the following statements describes the operating characteristics of a pre-combustion chamber?
- 883.On a diesel engine, using a distributor type air starting system, that is not running, which of the following methods may be used to detect leaking air starting valves?
- 884.Modern marine diesel engines using mechanical fuel injection, operate on a combustion cycle which is __________.
- 885.Which of the listed devices could be used as a substitute for a ring groove cleaning tool when needed to remove hard carbon deposits from piston ring grooves in preparation for installing new rings?
- 886.The main function of piston compression rings is to __________.
- 887.Visual inspection of a fuel injector valve, removed during overhaul, shows heat discoloration of the lower end of the valve. This is indicative of __________.
- 888.How often should the lubricating oil of a diesel engine be changed?
- 889.The flywheel reduces speed fluctuations by __________.
- 890.One of the factors limiting the amount of load which can be put on a modern marine diesel engine is the __________.
- 891.The over speed trip device installed in some diesel engines is automatically actuated by __________.
- 892.Modern marine diesel engines equipped with mechanical fuel injection operate on a combustion phase within the cycle which is __________.
- 893.Turbulence in the cylinder of a two-stroke/cycle main propulsion diesel engine is mainly created by __________.
- 894.In a single acting, two-stroke/cycle, diesel generator engine, the power impulse in an individual cylinder occurs __________.
- 895.Piston compression rings used in a diesel engine function to __________.
- 896.White smoke exhausting from a diesel engine can be caused by a __________.
- 897.The theoretical minimum compression ratio necessary to ensure compression ignition in a direct injection diesel engine is __________.
- 898.A diesel engine is operating under a normal load with low firing pressures and high exhaust temperatures. The most probable cause of this condition is __________.
- 899.A multi-orifice fuel injection nozzle is usually used with which of the listed types of combustion chamber?
- 900.A diesel engine which is rated for normal operation at a crankshaft speed of 800 RPM, is commonly classed as a __________.