USCG Motor Plants and Auxiliary Boilers – Question Bank Book 14 (BK14) — page 12
1960 questions with correct answers from the official USCG question bank (2008 edition), book 14 (Engine – USCG question bank, 2008 edition, Engine officers). Pass mark 70%. Click a question to see its answer.
Take the full practice test →Free USCG practice test with the real pass mark, no sign-up- 1101.Heat damage to fuel injection nozzles on small high-speed diesel engines, can be prevented by __________.
- 1102.When removing carbon that has accumulated at the air inlet ports of a two-stroke/cycle diesel engine, you should take precautions to prevent carbon particles from __________.
- 1103.Which of the following turbo charging systems channels the exhaust gases of each individual cylinder directly into the turbine rotor blades?
- 1104.The purpose of an interference angle in a diesel engine exhaust valve is to __________. I. work in conjunction with valve rotators to rotate the valve II. seat the valve quickly
- 1105.Comparing the exhaust gas output of each cylinder of a diesel engine is one method of determining if the engine load is balanced. This can be determined by the use of a __________.
- 1106.By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a __________.
- 1107.Which of the following instruments can be used to compare the exhaust gas output of each cylinder of a diesel engine to determine if the engine load is balanced?
- 1108.The major cause of problems occurring with fuel injection equipment is __________.
- 1109.Which of the listed types of superchargers will NOT have a volumetric capacity proportional to engine speed?
- 1110.According to Coast Guard Regulations (46 CFR), the highest boiler pressure where a tubular type gage glass may be installed is __________.
- 1111.When an additional load is applied to a diesel engine which is using an inadequately inflated air bladder clutch unit, you can expect __________.
- 1112.When two medium speed diesel engines are electrically coupled in parallel to a common propeller shaft which will operate at a speed less than 100 RPM, which of the operating conditions listed will apply?
- 1113.All oil-fired boilers, regardless of intended mode of operation, with automatic safety control systems must automatically close the burner valve when___________.
- 1114.A defective injector nozzle in a propulsion diesel engine can cause __________.
- 1115.Lubricating oil viscosity in an operating diesel engine can be reduced by __________.
- 1116.Which of the following statements is correct regarding a turbocharged four-stroke/cycle diesel generator?
- 1117.Coast Guard Regulations (46 CFR) require electric hot water supply boilers to be provided with a/an __________.
- 1118.Which of the listed effects would mixtures of ethylene glycol and phosphate compounds have on the metal surfaces of the cooling system of a diesel engine? I. Protects the coolant from freezing. II. Protects metallic surfaces from corrosion.
- 1119.Which of the listed effects would mixtures of phosphate compounds have on the metal surfaces of the cooling system of a diesel engine? I. Protects the coolant from freezing. II. Protects metallic surfaces from corrosion.
- 1120.Diesel engine cylinder head test cocks are used to __________.
- 1121.Dirt lodged on the nozzle valve seat of a fuel injection nozzle will cause __________.
- 1122.A sudden decrease in the diesel engine lube oil viscosity could be an indication of __________.
- 1123.The relative air pressure in the inlet manifold of a turbocharged diesel engine is usually __________.
- 1124.Waste heat boilers may be equipped with drains __________.
- 1125.An exhaust gas bypass is installed on a waste heat boiler in order to __________.
- 1126.A leaking diesel engine fuel injector will cause __________.
- 1127.A turbocharged diesel engine will have an intake manifold pressure __________.
- 1128.You are standing watch in the engine room with an auxiliary boiler. You should blow down a gage glass periodically to __________.
- 1129.If you hear a 'crackling' sound while standing watch in the engine room occurring within a general service system centrifugal pump, the most probable location of the noise would be the __________.
- 1130.Diesel engine cylinder head test cocks are used to __________.
- 1131.Problems with the diesel engine fuel injection pump are usually caused by __________.
- 1132.If you hear a 'crackling' sound while standing watch in the engine room coming from a centrifugal pump casing within a general service system, the most probable cause of the noise would be __________.
- 1133.If you hear a 'crackling' noise while standing watch in the engine room coming from a centrifugal pump within a general service system, the most probable cause of the problem would be __________.
- 1134.You are standing watch in the engine room on your vessel. The usual symptoms of cavitation in a centrifugal pump are __________.
- 1135.You are standing watch in the engine room of your vessel. Reduced capacity, accompanied by vibration and noise at the suction of a centrifugal pump, results from cavitation in the fluid being pumped. Cavitation describes the formation of __________.
- 1136.When turning a new cylinder head stud on a lathe, the minimum effective thread length of the stud is determined primarily by the __________.
- 1137.Which of the following problems is the main source of fuel pump and injection system malfunctions?
- 1138.Lube oil in the fresh water cooling system of a diesel engine may result from a __________.
- 1139.Which of the diesel engine components listed increases air density and helps to improve engine operating efficiency?
- 1140.Differential type needle valves in diesel engine fuel oil nozzles, are closed directly by __________. I. spring pressure II. fuel oil pressure
- 1141.Fuel oil strainers should be made of __________. I. copper II. Brass
- 1142.One end of a cylinder for a medium or high-speed diesel engine is sealed by the piston and rings, the other end is sealed by the __________.
- 1143.High cylinder firing pressure, accompanied by low exhaust temperature, can result from __________.
- 1144.Which harmful consequence may be the result of lube oil sludge accumulation?
- 1145.What is the function of the after cooler installed in the diesel engine air intake system?
- 1146.An electric motor failure in an electro-hydraulic steering gear system would cause the rudder to __________.
- 1147.An efficient seal between the cylinder block and cylinder heads on many diesel engines is obtained with __________.
- 1148.An increase in the fuel injection pump discharge pressure can be caused by a/an __________.
- 1149.The function of the after cooler installed between the turbocharger and intake manifold on some diesel engines, is to __________.
- 1150.A dirty fuel oil filter can be detected by __________. I. fuel oil analysis II. observing the pressure drop across the filter
- 1151.Irregular feeding or surging of the feed water supply to a low pressure distilling plant may be attributed to __________.
- 1152.Salinity cells are strategically installed in distilling units to indicate the __________.
- 1153.What would cause a coil type evaporator to require consistently higher steam coil pressure to maintain its output capacity?
- 1154.If the rated distillate production of a submerged tube type evaporator cannot be maintained with the maximum jacket water flow rate, the evaporator __________.
- 1155.Which of the terms listed below represents the operational speed at which excessive engine vibration is created?
- 1156.One cause of diesel engine fuel ignition delay is __________.
- 1157.Lubricating oil used in a diesel engine serves to __________.
- 1158.After cooling of a turbocharged diesel engine will result in __________.
- 1159.An indication of high salinity in the distillate discharged from a low pressure distilling plant can be the result of __________.
- 1160.If a higher than normal water level is observed through the inspection port of a low pressure distilling plant, you should suspect __________.
- 1161.An excessively high brine level in a low pressure distilling plant can be caused by __________.
- 1162.While standing watch in the engine room, you suspect an air leak while checking a low pressure distilling plant. Which of the following should be checked as a possible cause of the air leak?
- 1163.Vibrations from diesel engines and engine driven equipment are isolated from the hull structure by __________.
- 1164.Which of the conditions listed would cause simultaneous high cylinder firing pressure and low exhaust temperature?
- 1165.One function of diesel engine lubricating oil is to __________.
- 1166.When used in conjunction with a turbocharger, the main function of an after cooler is to __________.
- 1167.While standing watch underway, you notice carryover occurring in a low pressure distilling plant. This can be a result of __________.
- 1168.While standing watch underway, if the brine level of a low pressure distilling plant is above the sight glass, which action should be taken?
- 1169.A naturally aspirated diesel engine operating at a light load, when compared to operating at heavy load, has an fuel/air ratio value that is __________.
- 1170.Failure of the speeder spring in a mechanical governor will __________.
- 1171.Which of the devices listed is installed on a diesel engine to isolate some of the crankshaft vibrations caused by rotational and reciprocating forces?
- 1172.When fuel is injected too early in the injection cycle, it may cause the engine to have __________.
- 1173.Performance of a turbocharged engine can be improved by __________.
- 1174.Which of the following reasons represents why the designed compression ratio of a gasoline engine is lower than that of a diesel engine?
- 1175.The color of the exhaust gas from a diesel engine under normal load should be __________.
- 1176.Where would a metal-edge disk type strainer normally be found on a diesel engine lubrication system?
- 1177.According to 46 CFRs, which of the following devices is prohibited for use on automatic auxiliary boilers?
- 1178.When conducting a hydrostatic test on a water-tube auxiliary boiler, the test water should be heated to a temperature of at least 70°F (21°C). This is done to __________.
- 1179.Critical speeds occurring within the operating speed range of a main propulsion diesel engine may be changed, or have their damaging effects reduced by a/an __________.
- 1180.Early fuel injection timing is indicated by the cylinder pressure being __________.
- 1181.In a diesel engine, the function of lubrication oil is to provide __________.
- 1182.The purpose of an after cooler is to __________.
- 1183.The opening of an exhaust valve on a modern, large, low-speed, main propulsion diesel engine, may be actuated by __________.
- 1184.Which of the combustion parameters listed is used in a diesel engine, but NOT related to the injection system?
- 1185.Increasing the compression ratio of a diesel engine while maintaining the designed rate of fuel flow will result in __________.
- 1186.When fuel oil is accidentally mixed with lube oil which of the following processes can be used to separate them? I. filtering II. settling
- 1187.One advantage of dry cylinder liners used in a diesel engine is the __________.
- 1188.The highest indicated lube oil pressure in a diesel engine should be expected when the __________.
- 1189.Intercoolers installed on starting air compressors, reduce the possibility of __________.
- 1190.Between the periods of injection and ignition of the fuel, a diesel engine crankshaft rotates through the __________.
- 1191.Which of the listed set of conditions indicates early fuel injection timing?
- 1192.Electric starting motors for small auxiliary diesel engines require high current for operation and __________.
- 1193.If fuel injection in a diesel engine begins earlier than the design start of injection, ignition may be delayed because the __________.
- 1194.A diesel engine exposed to widely varying ambient temperatures should use a lubricating oil with __________.
- 1195.The air supplied to the cylinders by a turbocharger is often reduced in volume by a/an __________.
- 1196.In order to maximize the performance of a centrifuge, you can adjust the __________. I. number of disks in the stack II. frequency of shooting the bowl
- 1197.High firing pressures and a low exhaust temperature in a diesel engine may result from __________.
- 1198.The theoretical minimum compression ratio necessary to ensure compression ignition in a direct injection diesel engine is __________.
- 1199.A diesel engine will lose power if fuel injection occurs too early because the __________.
- 1200.While standing watch at sea, a main engine bearing high temperature alarm has just been indicated on the control panel. Your next action should be to _____________.