USCG Steam Plants – Question Bank Book 13 (BK13) — page 7
1769 questions with correct answers from the official USCG question bank (2008 edition), book 13 (Engine – USCG question bank, 2008 edition, Engine officers). Pass mark 70%. Click a question to see its answer.
Take the full practice test →Free USCG practice test with the real pass mark, no sign-up- 601.While on watch aboard a 900 psi steam vessel, you suddenly hear a loud, piercing, high-pitched noise. Which of the following actions should you take?
- 602.Which steam plant watch operating condition will require priority attention over the other conditions listed?
- 603.The terms 'swell' and 'shrink' relate to a change in boiler water level which __________.
- 604.Which of the flue gas components listed contributes to the greatest heat loss in a boiler?
- 605.Boilers equipped with steam atomized burners can be operated without changing burner tips because steam atomization __________.
- 606.The inability to maintain proper boiler water alkalinity, phosphate, or pH levels in a steam boiler, indicates a leak in the __________.
- 607.In comparison to a reaction turbine, a steam loss specific to an impulse turbine is known as __________.
- 608.The function of a safety valve on a marine boiler is to prevent the pressure in the boiler from rising above __________.
- 609.The term 'swell' relates to a change in boiler water level which __________.
- 610.Slag caused by water in the fuel oil will __________.
- 611.A high carbon monoxide content in the flue gases of a boiler indicates __________.
- 612.In most installations, the firing rate of a boiler using steam atomization is indicated by the __________.
- 613.While your vessel is steaming at a constant rate, the alkalinity in one of the boilers is decreasing steadily without requiring the use of extra makeup feed water. This condition could be caused by a leak in the __________.
- 614.In securing the main turbines, steam to the second stage air ejectors should be left on for a short period of time in order to __________.
- 615.A boiler safety valve must be capable of __________.
- 616.Lube oil cannot be efficiently filtered if its __________.
- 617.What will occur if the level of the atmospheric drain tank, (fresh water drain collector) is permitted to continuously rise while the vessel is underway?
- 618.Despite troubleshooting the system, the watch engineer has been unable to transfer fuel to the settler while underway. As the settler level is becoming dangerously low, the engineer should now __________.
- 619.The purpose of the relief valve in a fuel oil service system is to __________.
- 620.A high percentage of carbon dioxide in boiler flue gases indicates __________.
- 621.A basic comparison can be made between a low pressure evaporator operation and a main condenser with regards to the removal of non-condensable gases. The vacuum drag line for the main condenser is specifically connected in which area?
- 622.For a period of time immediately after being secured, turbines should be rotated slowly to avoid __________.
- 623.A boiler accumulation test is used to measure the __________.
- 624.The steam soot blower piping should be thoroughly drained before operating to prevent __________.
- 625.The level of the contaminated drain inspection tank continually decreases when steam is admitted to a fuel oil double bottom tank. You can expect __________.
- 626.The best indication that a bearing is being properly lubricated is by the __________.
- 627.If the flue gas oxygen content is too high, you should __________.
- 628.The firing range of a steam assisted fuel atomizer is regulated to cope with changes in the steam demand by varying the __________.
- 629.Which steam plant watch operating condition will require priority attention over the other conditions listed?
- 630.In a reaction turbine, the fixed blades function to __________.
- 631.Which of the conditions listed will provide 'blow down' after the safety valve has lifted?
- 632.In accordance with Coast Guard Regulations (46 CFR), all vessels having oil fired main propulsion boiler(s) must be equipped with __________.
- 633.Which of the following items should be checked each time the firing rate or forced draft pressure is adjusted?
- 634.The amount of fuel oil atomized by a steam atomization burner depends on the atomizing steam pressure, the fuel pressure and the __________.
- 635.Oil accumulation in boiler water would __________.
- 636.Which steam plant watch operating condition will require priority attention over the other situations listed?
- 637.As found in a reduction gear drive system, thrust bearings serve to __________.
- 638.Proper bracing and support of the boiler safety valve escape piping is necessary to __________.
- 639.If the steam flow input device to a two-element feed water regulator valve fails, the regulator operates as a __________.
- 640.Which following condition could occur if the distilled water tank level indicator has been giving an erroneously high reading?
- 641.In a tubular-bowl type centrifugal lube oil purifier, any solids separated from the oil are __________.
- 642.Efficient boiler operation is indicated when the percentage by volume of carbon dioxide present in combustion gases is between __________.
- 643.In a steam assist atomizer, the fuel oil/steam mix takes place entirely within the __________.
- 644.Foaming and moisture carryover in a boiler can be caused by an __________.
- 645.In a reaction turbine, the axial thrust due to the reactive force on the rotor blading drives the rotor __________.
- 646.Safety valves should be set to lift at or below the maximum working pressure allowed by the __________.
- 647.If the feed water flow sensor of a multi-element feed water regulator fails, the valve will be controlled as a __________.
- 648.The term 'shrink' relates to a change in boiler water level which __________.
- 649.The purpose of the air chamber at the discharge side of a steam reciprocating boiler feed pump is to __________.
- 650.Which steam plant watch operating condition will require priority attention over the other situations listed?
- 651.Generally, a 12% to 14% content of carbon dioxide in boiler flue gases indicates __________.
- 652.High temperature at the superheater outlet would be caused by __________.
- 653.Foaming in boiler water is a result of __________.
- 654.What physical changes will occur to the steam within a boiler that has been properly bottled up when additional heat is applied?
- 655.The bottom blow valve should be used to remove sludge and solids which have settled out of circulation after the boiler __________.
- 656.Which of the listed mediums should be used when water washing a boiler?
- 657.If a boiler is brought on the line with its steam pressure much higher than that of the boiler already on the line, there is danger of __________.
- 658.What steps should be taken if excessive steaming and vigorous bubbling occurs in the first section of the drain inspection tank?
- 659.When you are transferring fuel oil from one double bottom tank to another, precautions to be observed should include __________.
- 660.What percentage of CO2 in a boiler flue gas analysis would indicate perfect combustion?
- 661.Compared to the return flow oil burner system, an internally mixed steam atomizer requires __________.
- 662.Foaming in boiler water is caused by __________.
- 663.What will occur if the level of the atmospheric drain tank (fresh water collector) is permitted to continuously decrease while the vessel is underway?
- 664.In which type of turbine does a pressure drop exist through the fixed blades and the moving blades?
- 665.The purpose of the boiler bottom blow valve is to __________.
- 666.The distilled water tank has been determined to be 75% full. The tank connection to the pneumercator has been disconnected for a maintenance check. If the pneumercator operates correctly, the gage should indicate __________.
- 667.During an in port watch onboard a tank vessel while cargo operations are in progress, with the jacking gear engaged and running, you notice a 200 gallon drop in the reduction gear lube oil sump level. Which components or conditions should be checked immediately?
- 668.A steam propelled tank ship is operating at sea and despite troubleshooting the system by all the vessel's engineers, the transfer of fuel to the settler has not been possible and the settler will be empty in a few minutes. As the watch engineer, your NE
- 669.In which order should the chemical test analysis of boiler flue gas samples be made?
- 670.Which steam plant watch operating condition will require priority attention over the other situations listed?
- 671.Foaming in a boiler can be caused by __________.
- 672.What steps should be taken if excessive steaming and vigorous bubbling occurs in the first section of the drain inspection tank?
- 673.Which steam plant watch operating condition requires priority attention over the other conditions listed?
- 674.The guarding valve installed in a boiler bottom blow line prevents __________.
- 675.Which steam plant operating condition requires priority attention over the other situations listed?
- 676.The steam soot blower piping should be thoroughly drained before operating to prevent __________.
- 677.A salinity indicator cell is located in the __________.
- 678.A mechanical carbon dioxide recorder operates by detecting the difference between air and the __________.
- 679.Which of the following procedures represents the proper care of unused burners during low load conditions?
- 680.For a gravity type lube oil system, a remote pressure sensing device is installed at the point of highest static head pressure on the main unit to enable the watch engineer to __________. I. be certain that the bearings are being adequately lubricated II. determine if there is sufficient lube oil pressure to the main engine
- 681.Superheated steam is provided to operate the main steam turbine instead of saturated steam due to its __________. I. higher thermal energy per pound II. lesser erosive action on turbine blading
- 682.Operating a steam turbine propulsion unit at medium speed, in an area with extremely cold seawater and the main circulating pump providing full cooling water flow to the condenser will result in __________.
- 683.Before giving a boiler a bottom blow, it should be taken off the line and then the __________.
- 684.How is a diaphragm type steam whistle protected from damage due to entrained condensate?
- 685.An excessive power loss in a straight reaction turbine is commonly caused by __________.
- 686.When is the best time to give a boiler a bottom blow?
- 687.If the salinity indicator located in the main condensate pump discharge piping causes an alarm to sound there is a danger of __________.
- 688.The differential temperature of the main condenser circulating water during normal operation will be affected by __________. I. change in circulating pump speed II. the addition of make up feed
- 689.A boiler has a steam delivery capacity of 100,000 pounds per hour, and is equipped with four steam atomizing burners. If the load range of the burners is 4 to 1, this means that __________.
- 690.Excessive alkalinity of boiler water will cause ________.
- 691.Which of the precautions listed should be taken prior to blowing down a boiler water wall header?
- 692.Which condition would cause an excessively high level in the deaerating feed water tank (Direct Contact) heater during maneuvering?
- 693.In a steam assist fuel oil atomizer, the steam pressure is higher than the oil pressure at __________.
- 694.Babbitt metal is used to make __________.
- 695.A steam supplied heat exchanger will fail to maintain the designed quantity of heated liquid output if the __________. I. steam supply absolute pressure is increased II. tubes are leaking
- 696.If a boiler is being steamed at a high firing rate, blowing down a water wall header without taking any other precaution could result in __________.
- 697.A flue gas air heater, when installed in a boiler, would be accompanied by the operating characteristic(s) of __________. I. higher furnace temperatures than a boiler without an air heater II. greater heat absorption per pound of fuel
- 698.If a ship is to be laid up for an indefinite period, the steam side of the main condenser should be __________.
- 699.The efficiency of boiler combustion can be measured by the relative proportions of certain elements in the flue gases. The elements measured are __________.
- 700.Why should the fuel oil be re-circulated before lighting off a cold boiler?