USCG Steam Plants – Question Bank Book 13 (BK13) — page 6
1769 questions with correct answers from the official USCG question bank (2008 edition), book 13 (Engine – USCG question bank, 2008 edition, Engine officers). Pass mark 70%. Click a question to see its answer.
Take the full practice test →Free USCG practice test with the real pass mark, no sign-up- 501.To avoid acid corrosion of the economizer tubes when blowing tubes __________.
- 502.Maintaining low pressure in a condensing turbine exhaust trunk __________.
- 503.The maximum, safe, upper limit temperature of lubricating oil discharged from the purifiers is __________.
- 504.Which of the following methods is used to securely fasten the babbitt lining of a reduction gear bearing to its shell?
- 505.In a "D" type marine boiler, operating under constant load, which of the following conditions could cause the superheated steam temperature to rise above normal?
- 506.In which of the following types of condensers would you find the cooling water passing through tubes with the turbo generator exhaust steam directed around the outside of the tubes?
- 507.A poorly cleaned lube oil purifier bowl may result in __________.
- 508.Low stack gas temperatures due to light boiler loads should be avoided in order to reduce the __________.
- 509.You can secure the fuel supply to the boilers from outside the fire room by __________.
- 510.The end products of reactions occurring when boiler water is chemically treated, remain in the boiler and increase the need for __________.
- 511.While raising steam on a cold boiler, the air cock is to be closed after __________.
- 512.A main condenser utilizing a scoop for the circulation of seawater must be constructed as a __________.
- 513.Under normal firing rates, a reduction of the steam outlet temperature from an uncontrolled superheater could be caused by __________.
- 514.Low stack gas temperature should be avoided to reduce __________.
- 515.All fuel oil service pumps are equipped with a __________.
- 516.One of the purposes of chemically treating boiler water is to __________.
- 517.Why is it important to maintain good vacuum in a main turbine unit while operating astern?
- 518.The purpose of the boiler drum air cock is to __________.
- 519.Which of the following statements concerning the operation of a lube oil purifier is correct?
- 520.In order to maintain the required lube oil temperature leaving a lube oil cooler, where an automatic bypass valve is not provided, which of the following operations is correct?
- 521.Excessive soot deposits on the heating surfaces of a boiler uncontrolled interdeck superheater would be indicated by __________.
- 522.Lube oil is preheated before centrifuging in order to __________.
- 523.Which of the following represents the proper color of the flame end farthest from the boiler burner during normal operations?
- 524.The relief valve on the discharge side of the fuel oil service pump may discharge directly to the suction side of the pump, or to the __________.
- 525.What is the purpose of chemically treating boiler water?
- 526.Which of the following would contribute to the formation of an oil and water emulsion, in addition to acid formation?
- 527.The FIRST step in breaking vacuum on a main turbine unit should be to __________.
- 528.Which of the following is the best reason for opening the air cock when draining a water-tube boiler?
- 529.The peeling of boiler refractory associated with slagging, is caused by the __________.
- 530.The purpose of the cam-actuated steam valve used in a boiler soot blower system, is to __________.
- 531.A cause of high superheater outlet temperature is _________,
- 532.Which color burner flame would indicate too much excess air?
- 533.The relief valve on the discharge side of the fuel oil service pump may discharge directly to the settler, or to the __________.
- 534.An increase in the concentration of total dissolved solids in boiler water can result from __________.
- 535.A centrifuge will satisfactorily remove which of the listed substances from lube oil?
- 536.To raise vacuum on the main turbine unit, you should __________.
- 537.A nozzle reaction safety valve will lift at a pressure lower than required if the __________.
- 538.Under otherwise normal operating conditions, a drop in the steam temperature leaving an uncontrolled interdeck-type superheater could be caused by a/an __________.
- 539.In a tubular-bowl type centrifugal lube oil purifier, any solids separated from the oil are __________.
- 540.In a closed feed and water cycle, which of the conditions listed could prevent vacuum from reaching the desired level?
- 541.Coast Guard Regulations (46 CFR) require unfired pressure vessels with manholes to be hydrostatically tested __________.
- 542.An incandescent white flame in a boiler firebox would indicate __________.
- 543.The re-circulating valve provided in a straight mechanical boiler fuel oil service system, should be opened when __________.
- 544.An adequate phosphate reserve should be maintained in boiler water to __________.
- 545.Main steam turbine bearings are lined with __________.
- 546.Raising vacuum on a main turbine unit without using the turning gear will result in __________.
- 547.Babbitt is a metal alloy commonly used for lining __________.
- 548.Under normal operating conditions, a drop in the steam temperature at the outlet of an interdeck superheater could be caused by a decrease in __________.
- 549.Water boxes on condensers are vented to __________.
- 550.If an analysis of boiler flue gas determines there is 50% excess air for combustion, you should expect the nitrogen content of the flue gas to be approximately __________.
- 551.Steam assist fuel atomizers are converted to straight mechanical atomizers in order to __________.
- 552.Phosphates are used in the chemical treatment of boiler water to __________.
- 553.A lube oil sample taken from the main engine lube oil system has a dark yellow opaque color. This is the result of ____________ .
- 554.Prolonged astern operation of a turbine will cause __________.
- 555.The primary operational difference between a huddling chamber type safety valve and a nozzle reaction type safety valve is the __________.
- 556.Which of the following statements is correct regarding the selection of the proper size ring dam for a tubular-type lube oil purifier?
- 557.A lube oil sample is taken from the main engine lube oil system and visually inspected. Which of the following would indicate water contamination?
- 558.When main condenser tubes are rolled into both tube sheets, the effects due to differential expansion rates are minimized by the use of __________.
- 559.Under normal firing rates, which of the conditions listed could result in a low superheater outlet temperature?
- 560.If an analysis of boiler flue gas determines there is no excess air for combustion, you should expect the nitrogen content of the flue gas to be approximately __________.
- 561.In a disk-type purifier which component is used to separate lube oil into thin layers and create shallow settling distances?
- 562.Boiler water hardness in modern high pressure boilers should be kept as close to 'zero' as possible by chemically treating with __________.
- 563.A sudden unexplainable drop has occurred in the outlet temperature of an uncontrolled interdeck superheater on a boiler carrying a higher than normal TDS (total dissolved solids) reading. Which of the actions listed is required?
- 564.The purpose of the sentinel valve installed on a turbine casing is to __________.
- 565.What is the primary operational difference between a nozzle reaction safety valve and a huddling chamber safety valve?
- 566.In a disk type lube oil purifier, heavy impurities collect mostly __________.
- 567.The lube oil coolers installed in a gravity lubricating oil system are located between the __________.
- 568.The recommended vacuum should be maintained in the main condenser to __________.
- 569.If an analysis of boiler flue gas determines there is 100% excess air for combustion, you should expect the flue gas to have a nitrogen content of approximately __________.
- 570.Which of the fuel atomizers listed has the greatest firing range or turndown ratio?
- 571.In the prevention of moisture carryover from a marine boiler, one important consideration is to __________.
- 572.When excessive static boiler pressure has resulted in the initial lift of the valve disc, a huddling chamber safety valve will continue to lift open as a result of ___________,
- 573.While standing your engine room watch at sea, you notice the D.C. heater level dropping rapidly as indicated by the remote level indicator. Which of the following actions should be taken?
- 574.Prior to relieving the watch you should first check the fire room status by verifying the boiler steam drum level and _________.
- 575.One of the basic rules applying to the operation of a single-pass main condenser, is that the __________.
- 576.While trying to light off a burner on a semi-automated boiler, you note that the fuel oil solenoid valve at the burner will not stay open. Which of the following conditions could cause this problem?
- 577.A flue gas analysis is performed to determine the __________.
- 578.An advantage of steam atomization compared to mechanical atomization is __________.
- 579.If contaminated lube oil were allowed to settle undisturbed in a tank, into which layers would the contaminants separate?
- 580.The purpose of shroud bands secured to the tips of the turbine blades is to __________.
- 581.In a huddling chamber type safety valve, initial valve opening is caused by static pressure acting on the __________.
- 582.To determine the extent of lube oil system contamination you would __________.
- 583.Which of the following types of bearing lubrication schemes can carry the highest unit loading?
- 584.While making a round of the engine room, the oil in all of the main engine bearing sight glasses appears to be milky. The probable cause is __________.
- 585.Which of the following would cause the dowel or locking lip of a split-type, precision insert, main bearing to shear and allow the bearing to rotate with the journal?
- 586.A chemical based analysis of boiler stack gases is taken to __________.
- 587.If boiler water chemicals are decreasing in one boiler and increasing in the other boiler, while both are steaming at normal rates, a leak probably exists in the __________.
- 588.The most practical method of determining the condition of a shaft bearing while the shaft is in operation is to __________.
- 589.Steam supplied to the main propulsion turbines is __________.
- 590.In a huddling chamber safety valve, the initial valve opening is caused by __________.
- 591.During the routine inspection of an operating centrifugal lube oil purifier, you notice oil discharging through the water discharge port. Which of the following actions should be taken?
- 592.One limiting problem of lube oil filters restricting their use in large lube oil systems is __________.
- 593.A condensate re-circulating line is provided to the main condenser in a closed feed water system to __________.
- 594.In a tubular bowl centrifugal purifier, lube oil is rotated at the same speed as the bowl by the __________.
- 595.Which of the stack emissions listed represents a heat loss from the furnace?
- 596.Boilers equipped with steam atomizers can operate over a wide load range without cutting burners in and out because __________.
- 597.The vessel is currently operating at sea. Despite troubleshooting the system, the engineers of the vessel have been unable to transfer fuel to the settler. As the settler level is becoming dangerously low, they should now __________.
- 598.Which of the steam losses listed would be associated with a multistage impulse turbine rather than a multistage reaction turbine?
- 599.Why is it occasionally necessary to verify the accuracy of the distilled water make-up feed tank level remote indicator?
- 600.While standing your engine room watch at sea, you notice the D.C. heater level is dropping below normal as indicated by the remote level indicator. The boiler drum level is observed to be normal, as is the main condensate pump discharge pressure. Therefore, you should __________.