USCG Electricity – Question Bank Book 12 (BK12) — page 6
1209 questions with correct answers from the official USCG question bank (2008 edition), book 12 (Engine – USCG question bank, 2008 edition, Engine officers). Pass mark 70%. Click a question to see its answer.
Take the full practice test →Free USCG practice test with the real pass mark, no sign-up- 501.Upon failure of the normal power supply, the emergency generator is placed on the line by the __________.
- 502.Routine maintenance of a ship's service alternator should include __________.
- 503.Nickel-cadmium storage batteries are superior to lead-acid batteries because they __________.
- 504.Which of the following meters uses a shunt connected in series with the load, but parallel with the meter movement?
- 505.Electrical machinery insulation will break down more rapidly due to __________.
- 506.The speed of a multi-speed, squirrel-cage, induction motor operating in a fixed frequency system can be changed by __________.
- 507.In the construction of D.C. motors, parts of both the series and shunt fields are wound on the __________.
- 508.A handheld reflective digital tachometer could give a false reading if __________.
- 509.Which of the listed sections of an emergency switchboard is used to supply power for alarm signals under emergency conditions?
- 510.Which of the listed ranges represents the specific gravity for the electrolyte of a fully charged lead-acid battery at room temperature?
- 511.Inductance is the property of an electric circuit that __________.
- 512.An important factor in reducing D.C. motor commutator wear is __________.
- 513.When removing ball or roller bearings from the shaft of a motor, you should use a __________.
- 514.The rotation of a three-phase induction motor can be reversed by __________.
- 515.When troubleshooting a console circuit card which is suspected of being faulty, the first step would be to __________.
- 516.The amount of mechanical force or torque produced by an electric motor depends on the __________.
- 517.Capacitance is the property of an electric circuit opposing a change in the __________.
- 518.A megohmmeter is connected to each end of an individual motor winding. A low ohm reading indicates __________.
- 519.The frequency of an AC generator is controlled by the __________.
- 520.The 24 volt DC bus on the emergency switchboard is used to supply power to the __________.
- 521.The life expectancy of electrical insulation, is approximately halved for an increased operating temperature of __________.
- 522.Under normal conditions, storage batteries used for starting the emergency diesel generator are maintained in a charged state by which of the following methods?
- 523.At high discharge rates, nickel-cadmium storage batteries are superior to lead-acid batteries because they __________.
- 524.A megohmmeter can be used to test for __________.
- 525.The frequency of an alternator is controlled from the main switchboard by adjusting the __________.
- 526.The reversal of an AC, three-phase, induction motor is accomplished by __________.
- 527.When troubleshooting a console circuit card suspected of being faulty, first check for proper voltages to the card and then __________.
- 528.A useful instrument for checking 3 phase A.C. motor performance by measuring possible unbalanced currents is the __________.
- 529.In an AC circuit, the inductive reactance of a coil varies with the __________.
- 530.Complete maintenance of electrical motors should include periodic checks for machine __________.
- 531.In order to take a current reading with a 'clamp-on' ammeter, the instrument's jaws __________.
- 532.The number of cycles per second occurring in AC voltage is known as the __________.
- 533.What is the approximate discharge voltage produced by one cell of a wet type nickel-cadmium battery?
- 534.When checking for a possible single phase condition in a three-phase induction motor circuit, which of the following electrical measuring devices would be the most practical to use to locate the malfunction?
- 535.Sparking of D.C. motor brushes can be caused by __________.
- 536.A hydrometer is used to measure the __________.
- 537.When troubleshooting an alkaline storage battery, a weak or dead cell is best located by __________.
- 538.When a megohmmeter is used to test the dielectric strength of wire insulation, the initial dip of the pointer toward 'zero' is caused by __________.
- 539.The voltage of an operating AC turbo generator is raised or lowered by adjusting the __________.
- 540.Electrical insulation is classed by the __________.
- 541.In D.C. motor construction, commutating windings are wound on __________.
- 542.When troubleshooting motor controllers, a shorted relay or contactor coil is often indicated by __________.
- 543.When a battery-charging panel is being used, the batteries will discharge if __________.
- 544.Electric current is the flow of electrons through a conductor. The rate of this flow is measured as __________.
- 545.If the pointer on a megger fails to return to 'zero' when not being used, the __________.
- 546.If the driving torque, such as that produced by a diesel engine, creates pulsations when coupled with a synchronous generator operating in parallel, the generator rotor may be periodically pulled ahead or behind its normal position as it rotates. This hunting condition can be reduced by __________.
- 547.Which of the following statements represents the FIRST step in seating new brushes on slip rings?
- 548.When replacing fuses, always make sure __________.
- 549.Periodic testing of circuit breakers is necessary to assure that a correctly rated and properly installed unit __________.
- 550.Voltage will always lead current in a/an __________.
- 551.The need for insulation cleaning may be determined by __________.
- 552.Motor name plate data includes " degrees Centigrade temperature rise ". This indicates the __________.
- 553.When using a megohmmeter to test the dielectric strength of wire insulation, a continuous series of slight downscale kicks by the pointer is result of __________.
- 554.You are attempting to parallel two AC generators and the synchroscope pointer is revolving in the slow direction. This indicates that the frequency of the incoming machine is __________.
- 555.Periodic testing by a shore side support technician using a special camera which can detect potentially dangerous loose or corroded bus bar and controller connections is termed __________.
- 556.When troubleshooting a console circuit card suspected of being faulty, first check operating voltages, clean the card and then __________.
- 557.Four lamps are connected in parallel in a single circuit. If one of the lamp burns out, the others will __________.
- 558.When the electrolyte level of a lead-acid storage battery has decreased due to normal evaporation, the level should be reestablished by adding __________.
- 559.When troubleshooting a motor controller, all indications are that a relay coil should be energized. If there were no magnetic pull, with rated voltage measured across the coil, the most probable cause would be that the __________.
- 560.Discharge switches are often located on hand-driven meggers. The purpose of these switches is to discharge capacitive charges stored in the __________.
- 561.When shipboard electrical distribution circuits are connected in parallel, additional parallel circuits will cause the total circuit resistance to __________.
- 562.Which of the listed classes of electrical insulation is suited for the highest operating temperature?
- 563.Which of the following procedures represents the best method to prevent the freezing of batteries continuously exposed to low temperatures?
- 564.Ambient temperature is the __________.
- 565.A ohmmeter can be used to test for __________.
- 566.You are attempting to parallel two AC generators and the synchroscope pointer is revolving slowly in the fast direction. You should __________.
- 567.When the control handle is in the 'off' position, the solenoid actuated brake of an electric winch is __________.
- 568.In D.C. motor construction, the armature coils' ends are __________.
- 569.Electric circuits are protected against overloads and short circuits by means of a/an __________.
- 570.Which of the substances listed should be applied to battery terminals to help prevent corrosion?
- 571.When troubleshooting a console circuit card suspected of being faulty, the last step would be to __________.
- 572.The armature cores of the D.C. motors are constructed with laminations to __________.
- 573.When a megohmmeter is being used to test insulation resistance, current leakage along the surface of the insulation is indicated by the megohmmeter pointer __________.
- 574.While paralleling two (2) AC generators using synchronizing lamps only, both lamps will go dark when the generators are __________.
- 575.The direction of rotation of a DC propulsion motor can be reversed by __________.
- 576.Motor controllers are seldom troubled by grounds because __________.
- 577.Which of the listed groups of electrical insulation materials is best suited for the highest operating temperatures?
- 578.Capacitors can be used in electric distribution systems to improve power factor. This is accomplished by seesawing energy between the capacitor and the __________.
- 579.A lead-acid battery cell sustaining a short circuit __________.
- 580.The propeller shaft speed in a turbo-electric, synchronous, propulsion drive motor is changed by varying the __________.
- 581.When the voltage and the current developed in an AC circuit reach their peak values at the same time, the power factor is considered to be __________.
- 582.Which of the instruments listed is used to check insulation resistance?
- 583.You are paralleling two alternators. The synchronizing lamps grow dim and are totally darkened as the synchroscope pointer approaches the 0° position. This indicates that the __________.
- 584.If you reverse both the field and the armature connections to a DC propulsion motor, __________.
- 585.A fuse will blow for all the listed reasons EXCEPT __________.
- 586.The direction of propeller shaft rotation in a turbo-electric AC synchronous propulsion drive motor is changed by reversing the __________.
- 587.When voltage and current developed in an AC circuit reach their peak values at the same time, the power factor is __________.
- 588.The direction of rotation of a DC propulsion motor can be changed by reversing the __________.
- 589.In general, D.C. propulsion motor brush sparking can be caused by __________.
- 590.Automatic voltage regulators provided on switchboards function to __________.
- 591.High pressure compressed air should not be used to clean electric motors or controller equipment because __________.
- 592.Which of the following problems is indicated if a lead-acid battery begins to gas violently when it is first placed on charge?
- 593.Moisture absorbed in the windings or condensed on the surface of electrical machinery insulation __________.
- 594.The voltage developed by an AC generator is controlled by varying the __________.
- 595.In which of the situations listed will a megohmmeter give the most accurate readings?
- 596.You are attempting to parallel two AC generators, and the synchroscope pointer is revolving in the fast direction. This indicates that the frequency of the incoming machine is __________.
- 597.Temporary repairs to an open DC propulsion armature coil can be made by __________.
- 598.When shore power is being connected to a ship in dry dock, __________.
- 599.If a fuse of correct size and type blows frequently, __________.
- 600.If violent gassing occurs when a lead-acid storage battery is first placed on charge, the __________.