USCG Deck Safety – Question Bank Book 4 (BK4) — page 33
4852 questions with correct answers from the official USCG question bank (2008 edition), book 4. Pass mark 70%. Click a question to see its answer.
Take the full practice test →Free USCG practice test with the real pass mark, no sign-up- 3201.While drilling loaded as shown in Sample Load Form #4 (Drilling), the DEEP DRILLER suffers a sudden unexpected starboard and aft inclination. The wind and waves are light. What might have caused the inclination?
- 3202.While drilling loaded as shown in Sample Load Form #4 (Drilling), the DEEP DRILLER suffers an unexpected but slowly increasing starboard and aft inclination. The wind and waves are light. This inclination could have been caused by __________.
- 3203.While drilling loaded as shown in Sample Load Form #4 (Drilling), the DEEP DRILLER suffers an unexpected but slowly increasing port and aft inclination. The wind and waves are light. This inclination could have been caused by __________.
- 3204.While drilling loaded as shown in Sample Load Form #4 (Drilling), the DEEP DRILLER suffers an unexpected but slowly increasing port and forward inclination. The wind and waves are light. This inclination could have been caused by __________.
- 3205.While drilling loaded as shown in Sample Load Form #4 (Drilling), the DEEP DRILLER suffers an unexpected but slowly increasing starboard and forward inclination. The wind and waves are light. This inclination could have been caused by __________.
- 3206.In storm conditions, when the environmental conditions are such that the DEEP DRILLER has disconnected the marine riser, the two leeward mooring lines should be __________.
- 3207.The equipment required to remove an on-deck oil spill on a barge transferring oil must either be carried on board or __________.
- 3208.In storm conditions, when slacking the leeward mooring lines of the DEEP DRILLER, maintain in the chain locker at least __________.
- 3209.While loaded as shown in Sample Load Form #5 (Survival), an estimated 250 long tons of snow and ice accumulates on the DEEP DRILLER at an estimated height of 127 feet. Assuming no corrective ballasting, what is the rise in the height of the center of gravity corrected for longitudinal free surface effects?
- 3210.You may have to give artificial respiration after an accidental __________.
- 3211.While loaded as shown in Sample Load Form #5 (Survival), an estimated 250 long tons of snow and ice accumulates on the DEEP DRILLER at an estimated height of 127 feet. Assuming no corrective ballasting, what is the new height of the center of gravity corrected for longitudinal free surface effects?
- 3212.While loaded as shown in Sample Load Form #5 (Survival), an estimated 250 long tons of snow and ice accumulates on the DEEP DRILLER at an estimated height of 127 feet. Assuming no corrective ballasting, what is the margin on maximum allowable KG?
- 3213.You are in charge of a fishing vessel with 18 individuals on board. You are required to conduct drills and give safety instruction at least once __________.
- 3214.While loaded as shown in Sample Load Form #5 (Survival), an estimated 250 long tons of snow and ice accumulates on the DEEP DRILLER at an estimated height of 127 feet. Assuming no corrective ballasting, what is the new draft?
- 3215.Which statement is CORRECT with respect to inserting an airway tube?
- 3216.The rescuer can best provide an airtight seal during mouth to mouth ventilation by pinching the victim's nostrils and __________.
- 3217.If someone suffers a heart attack and has ceased breathing, you should __________.
- 3218.The necessity for administering artificial respiration may be recognized by the victim's __________.
- 3219.In order to initiate CPR on a drowning victim, __________.
- 3220.During the passage of a severe storm, the DEEP DRILLER is at survival draft. Strong winds are blowing from the starboard. A careful load form calculation determined that, although the unit is level, the TCG is 2.0 feet to starboard. The value of the wind heeling moment is __________.
- 3221.Treatments of heat exhaustion consist of __________.
- 3222.A patient suffering from heat exhaustion should be __________.
- 3223.The DEEP DRILLER is engaged in wire line logging. You have 10,000 feet of drill pipe and bottom hole assembly in the set back. Marine weather forecasts are predicting weather with winds in excess of 70 knots. Your first step to prepare for the storm should be to __________.
- 3224.The symptoms of heat exhaustion are __________.
- 3225.If the DEEP DRILLER is damaged, the unit is designed to avoid downflooding in wind speeds up to __________.
- 3226.Heat exhaustion is caused by excessive __________.
- 3227.In the event of damage to the DEEP DRILLER which results in flooding to one of the lower-hull tanks, pump from __________.
- 3228.Which procedure should be followed when individuals are rescued in cold climates and suffer from hypothermia?
- 3229.The most important consideration in the event the Deep Driller suffers damage is __________.
- 3230.Because of the presence of 75 knot winds, the DEEP DRILLER is at survival draft. KGT is 3.24 feet less than the maximum allowed. What is the value of GMT?
- 3231.While providing assistance to a victim of an epileptic seizure, it is most important to __________.
- 3232.To treat a person suffering from heat exhaustion, you should __________.
- 3233.Seasickness is caused by rolling or rocking motions which affect fluids in the __________.
- 3234.Symptoms of sea sickness include __________.
- 3235.Symptoms of sugar diabetes include __________.
- 3236.The symptoms of a fractured back are __________.
- 3237.What is the procedure for checking for spinal cord damage in an unconscious patient?
- 3238.What are symptom(s) of a ruptured appendix?
- 3239.When administering first aid you should avoid __________.
- 3240.The primary concern in aiding a back injury patient is __________.
- 3241.What is the decrease in longitudinal moments for the Deep Driller if 2.0 feet of ballast is transferred from 1S to 10P?
- 3242.The abandon ship signal sounded by the vessel's whistle is __________.
- 3243.What is the ullage in P-Tank #4 of the DEEP DRILLER if the weight is 75.24 long tons?
- 3244.The signal given to commence lowering the lifeboats is __________.
- 3245.The sounding in fuel oil tank 4P on the DEEP DRILLER is 8.75 feet. What are the transverse moments for this amount of fuel?
- 3246.If you continue to wear extra clothing when entering the water after abandoning your vessel, it will __________.
- 3247.What is the weight of cement in P-tank #1 of the Deep Driller if the ullage is 3.4 feet?
- 3248.When a ship is abandoned and there are several liferafts in the water, one of the FIRST things to be done is __________.
- 3249.If more than one liferaft is manned after the vessel has sunk, __________.
- 3250.One of the first actions to be taken by survivors when they have boarded an inflatable liferaft is to __________.
- 3251.What is the weight of barite in P-tank #4 of the DEEP DRILLER if the ullage is 3.4 feet?
- 3252.You have abandoned ship in tropical waters. Which procedure should be used during a prolonged period in a liferaft?
- 3253.What is the weight of bulk in P-tank #1 of the DEEP DRILLER if the ullage is 2.3 feet?
- 3254.What are the vertical moments for P-Tank #1 on the DEEP DRILLER if the ullage is 3.0 feet?
- 3255.When using the rainwater collection tubes of a liferaft, the FIRST collection should be __________.
- 3256.What is the VCG for the cement in P-Tank #1 on the DEEP DRILLER if the ullage is 6.4 feet?
- 3257.When you hear three short blasts on the ship's whistle and the same signal on the general alarm bells, you __________.
- 3258.The signal for a fire emergency on an OSV is __________.
- 3259.While reading the muster list you see that "3 short blasts on the whistle and three short rings on the general alarm bell bells" is the signal for __________.
- 3260.What is the VCG of the additional load if P-tank #4 in the DEEP DRILLER Sample Load Form #1 (Transit) is completely filled ?
- 3261.When the ullage is 6.4 feet in P-Tank #5 for the Deep Driller, what is the value of the longitudinal moment?
- 3262.When the ullage is 5.7 feet in P-Tank #6 for the Deep Driller, the transverse moment for P-Tank #6 is __________.
- 3263.Which of the following steps should normally be taken first by those who have boarded a liferaft in an emergency situation?
- 3264.What are the longitudinal moments for the contents of P-tank #1 of the DEEP DRILLER if the ullage is 2.3 feet?
- 3265.With no alternative but to jump from an OSV, the correct posture should include __________.
- 3266.What are the vertical moments for the cement contents of P-tank #1 of the DEEP DRILLER if the ullage is 2.3 feet?
- 3267.For the DEEP DRILLER, what are the transverse moments for a sounding of 5 feet in tank C3P?
- 3268.All OSV personnel should be familiar with survival craft __________.
- 3269.For the DEEP DRILLER, what are the longitudinal moments for a sounding of 15 feet in tank C3P?
- 3270.A liferaft which has inflated bottom-up on the water __________.
- 3271.For the DEEP DRILLER, What are the vertical moments for a sounding of 10 feet in tank C3P?
- 3272.Provided every effort is used to produce, as well as preserve body moisture content by avoiding perspiration, how long is it normally possible to survive without stored quantities of water?
- 3273.If help has not arrived in 10-12 hours after having abandoned an OSV in a survival craft, you should __________.
- 3274.The sounding in fuel oil tank 4P on the DEEP DRILLER is 8.75 feet. What are the longitudinal moments for this amount of fuel?
- 3275.If you have to abandon ship, and enter a liferaft, your main course of action should be to __________.
- 3276.The sounding in tank 1P of the DEEP DRILLER is 7.58 feet. What are the vertical moments for this quantity of ballast?
- 3277.If you are forced to abandon ship in a rescue boat, you should __________.
- 3278.Among the valves to open when deballasting using tanks 1P and 10P of the DEEP DRILLER is __________.
- 3279.When abandoning an OSV, following the launching of the survival craft you should __________.
- 3280.What is the change in longitudinal moments for the DEEP DRILLER if 103.48 long tons of ballast is discharged from a full ballast tank 1P?
- 3281.To keep injured survivors warm in the water after abandoning an OSV, when no rescue craft is in sight, they should __________.
- 3282.If there are a number of survivors in the water after abandoning an OSV and no rescue craft are in sight, they should __________.
- 3283.Once the daily ration of drinking water in a survival situation has been established, the drinking routine should include __________.
- 3284.What is the change in transverse moments for the DEEP DRILLER if 103.48 long tons of ballast is discharged from a full ballast tank 1P?
- 3285.In the first 24 hours after abandoning a vessel, water should be given only to personnel who are __________.
- 3286.What is the change in vertical moments for the DEEP DRILLER if 103.48 long tons of ballast is discharged from a full ballast tank 1P?
- 3287.After abandoning a vessel, water consumed within the first 24 hours __________.
- 3288.What is the change in longitudinal moments for the DEEP DRILLER if 103.48 long-tons of ballast is transferred from a full ballast tank 1P to an empty ballast tank 10S?
- 3289.You have abandoned ship and are in charge of a liferaft or survival craft. How much water per day should you permit each person to have after the first 24 hours?
- 3290.What is the change in transverse moments for the DEEP DRILLER if 103.48 long-tons of ballast is transferred from a full ballast tank 1P to an empty ballast tank 10S?
- 3291.Among the valves to open on the DEEP DRILLER, if you have to transfer ballast from Tank 10P to Tank 1S using #1 ballast pump, is valve __________.
- 3292.Among the valves to open on the DEEP DRILLER, if you have to transfer ballast from Tank 1P to Tank 10S using #1 ballast pump, is valve __________.
- 3293.What port-side valves must be open to transfer ballast from Tank 10P to Tank 1P on the DEEP DRILLER, using the Port #1 ballast pump?
- 3294.What port-side valves must be open to transfer ballast from Tank 1P to Tank 10P on the DEEP DRILLER using the Port #1 ballast pump?
- 3295.Fire dampers prevent the spread of fire by __________.
- 3296.The painter of the inflatable liferaft has a length of __________.
- 3297.What is the change in the vertical moments for the DEEP DRILLER if 2.0 feet of ballast is transferred from a full ballast tank 3P to an empty ballast tank 10P?
- 3298.The sounding in tank 1P of the DEEP DRILLER is 7.58 feet. What are the longitudinal moments for this quantity of ballast?
- 3299.On the DEEP DRILLER, among the valves to open when transferring ballast from Tank 1S to Tank 10P using the #1 ballast pump is valve __________.
- 3300.On the DEEP DRILLER, among the valves to open when transferring ballast from Tank 10S to Tank 1P using the #2 ballast pump is valve __________.