F5 Electrical Engineering — Management Level
333 questions with correct answers. Click a question to see its answer.
Take the full test →Random exam test generator, free, no registration- 1.Which generators do we call compound and what is their application?
- 2.If we want not to pass a certain value to the desired parameter during regulation with a PID controller we should:
- 3.What regulation law is applied in regulating an electric motor by increasing its voltage at reduction of its rotor revolutions, during its progressive loading ?
- 4.When the temperature starts to rise, even before it has reached the desired level, the controller stops the heater to prevent overheating. What law of regulation is applied ?
- 5.Which statement does not apply to dinistors?
- 6.What type is the frequency meter used for synchronization and reading of the frequency of the current supplied to the main switchboard buses?
- 7.The excitation of an electrocoupler / clutch is reduced at low revs in order to:
- 8.What will happen to the winch master switch components if its box cover gasket is damaged?
- 9.How should the silver-plated contact plates of relays and contactors be kept in good technical condition?
- 10.Which of the following causes the most serious damage to electrical equipment during long idle periods (for example, electric motors of cargo pumps on ships in long transition)?
- 11.When using a voltmeter for tracking failures/malfunctions of electronic circuits, to reduce the "load" of the circuit usually the voltmeter is used with/through:
- 12.The electric wires and the insulation of one electric motor must be painted with:
- 13.What method of cleaning dust and other foreign particles should be used to clean electrical equipment in order to reduce possible damage to its components?
- 14.From the following, which type of electric motor will be the safest and most reliable for use on an open deck in adverse weather conditions ?
- 15.A cylindrical fuse should always (if necessary) be removed with:
- 16.What is differential protection?
- 17.Which of the following statements is not true about the purpose of fluorescent lighting chokes?
- 18.What is the purpose of the air gap in chokes?
- 19.Which process has the greatest influence on the duration of technical operation of fluorescent lamps?
- 20.What is the purpose of the capacitor and how is it connected to the fluorescent lamp circuit?
- 21.What is a reactor in high current circuits?
- 22.A farad is a unit of measure for:
- 23.As a general rule, your first action in troubleshooting a damaged electrical device should be:
- 24.Which of the following is used in pressure measurement and its conversion into an electrical signal ?
- 25.In the alarm system of the engine telegraph are used Selsins connected in indicator mode. The alarm sounds when the rotors are in:
- 26.What are the conditions for parallel operation of transformers?
- 27.How would you define the term "magnetizing current" of the transformer?
- 28.The transformer is functioning normally at a voltage of 220 V alternating current. What will happen if we connect it to 110V direct current ?
- 29.What is the relationship between the current and the number of windings in the transformer coils?
- 30.A three-phase electric motor at nominal speed and load operates at 200 Ampere current. How much is its starting current?
- 31.The insulation of the stator windings of 450V generator with a power of 659 kW, measured after a long period of inactivity, shall be:
- 32.Unloading the generator before shutdown must be smooth due to the danger of:
- 33.Which of the following radiations has the highest frequency of oscillation?
- 34.What is the "skin effect" in wires?
- 35.The magnetic field flux is measured in :
- 36.Which protection is designed to protect the human body from electric shock?
- 37.Does the fault current protection apply in marine power plants and marine electrical equipment?
- 38.What is the main advantage of autotransformers?
- 39.Why must the excitation coils of direct current generators be connected in series?
- 40.Thermal overcurrent protection cannot be reset after tripping, because:
- 41.The automatic voltage regulator /AVR/ changes the generator output voltage by:
- 42.Before synchronizing, the voltage and frequency of the generator current are controlled by:
- 43.What sensor is used to measure the effective torque of the ME?
- 44.Thermocouples have:
- 45.When calibrating the meter, what is usually the first step?
- 46.Why is the thermocouple signal amplifier output in milliamps?
- 47.For which of the listed systems will a PID controller be installed?
- 48.If at 75% load of two generators running in parallel, one of them shuts down, what emergency action will we take?
- 49.In which of the following processeswill the time constant have minimal significance?
- 50.Electric propulsion motors are usually:
- 51.Can direct current (DC) be transformed?
- 52.Which coil provides the transformation of the electric current into a magnetic field?
- 53.Which statement is false about xenon lighting?
- 54.When preparing the main switchboard to receive electric power, which action wil we take first?
- 55.When testing an electric machine after repair, which parameters do we check in action first?
- 56.Which statement is false regarding the ship radar?
- 57.From two generators operating in parallel, with balanced load, one runs with higher current, what is the reason for this?
- 58.What determines the power factor of a generator connected alone to the busbars of the main switchboard ?
- 59.The BIOS system of the personal computer is located in:
- 60.The purpose of compensating windings of synchronous electric motors is:
- 61.Which statement is true about equipment supplied with 24 V through a Zener barrier?
- 62.If we connect two consumers in series with resistances of 6 and 12 ohms, what will be the total resistance of the circuit?
- 63.What is the Zener barrier?
- 64.What does the stopping of the synchronoscope arrow indicate when two generators are in parallel?
- 65.When a three-phase star-connected generator is operating, the neutral :
- 66.In the event that the prime mover fails, the alternator is protected from motoring by:
- 67.The power that is lost in heat in coils when current flows through them is known as:
- 68.Which of the following is not required for synchronizing generators?
- 69.The revolutions of an induction motor compared to the revolutions of the rotating magnetic field in it:
- 70.The resistance of a conductor change:
- 71.Which of the following devices is not powered by emergency power sources?
- 72.The reactive load distribution is carried out by:
- 73.The transfer of electrical signals between two electronic devices is carried out by galvanic insolation. For this purpose, the following are used:
- 74.Which statement is not true regarding electrical induction?
- 75.Which of the statements applies to the wires?
- 76.Which of the properties of ferroelectrics is used the most in electronics?
- 77.What does the capacity of the capacitor not depend on?
- 78.Charging the alkaline batteries should be stopped when the density of the electrolyte reaches what value?
- 79.Which monitoring and control systems are built on the principle of radar technology?
- 80.Which element of electronics is used when a given parameter needs to be monitored whether it is below or above a given threshold ?
- 81.The speed of the DC motor is:
- 82.Which group of signals are not fed to the integrated alarm system during unattended service?
- 83.Which of the following automatic control systems is always of cascade type?
- 84.How many minutes do you have to aknowledge an alarm in order to avoid activation of ship`s general alarm?
- 85.What is the function of the I/P transducer?
- 86.Which of the following machines has squirrel cage rotor:
- 87.Which of the listed systems do we not identify with ship power systems?
- 88.Which of the distribution systems of electricity finds its most limited application in ships power plants?
- 89.How to choose the thermal protection for asynchronous motors?
- 90.Which element of electronics can be turned off by breaking the anode circuit; lowering the anode current and voltage below the trip point and change the polarity of the anode voltage ?
- 91.How many starters are used to start stop and reverse a two-speed asynchronous motor, in the channels of the stator of which two independent three-phase coils are located ?
- 92.The fixed part of the asynchronous electrical motor are called:
- 93.The moving part of the asynchronous electrical motor are called:
- 94.Zero protection is protection from:
- 95.What is the transformation ratio of the shore isolation transformer for powering the ship from the shore grid
- 96.For what purpose are optocouplers used in the connections of peripheral devices with the interface circuits in microprocessor control systems?
- 97.When must the equipment of the autosteering devices be checked?
- 98.Which winding provides the self-synchronization of three-phase synchronous generators with an salient-pole inductor?
- 99.Which element of a DC generator serves as a mechanical rectifier?
- 100.What is the function of the separators between battery plates: