USCG Engineering Safety – Question Bank Book 15 (BK15) — page 21
2172 questions with correct answers from the official USCG question bank (2008 edition), book 15 (Engine – USCG question bank, 2008 edition, Engine officers). Pass mark 70%. Click a question to see its answer.
Take the full practice test →Free USCG practice test with the real pass mark, no sign-up- 2001.Which of the following statements describes how the main bank of CO2 bottles is released into an engine room from most fixed CO2 fire extinguishing systems?
- 2002.During fueling operations, which of the listed precautions should be taken when topping off fuel tanks?
- 2003.The most critical part of the bunkering operations, which can result in an oil spill, is when the __________.
- 2004.After fuel tanks have been filled and bunkers completed, which of the listed procedures should be followed next?
- 2005.If the overflow tank high-level alarm sounds while the fuel oil tanks are being topped off, the engineer should __________.
- 2006.To avoid shock pressures in the fuel oil filling hoses while you are topping off tanks, the __________.
- 2007.When a fuel oil tank is being topped off during bunkering operations, the tank valve should be closed __________.
- 2008.The amount of expansion space to be left in a fuel tank when fuel oil is being received, is determined by the __________.
- 2009.According to Coast Guard Regulations (46 CFR), which of the following statements is true concerning fixed carbon dioxide fire extinguishing systems?
- 2010.Coast Guard Regulations (46 CFR) for carbon dioxide fixed fire extinguishing systems require __________.
- 2011.Coast Guard Regulations (46 CFR Part 34) state that any space containing charged CO2 cylinders, shall be properly ventilated to prevent a temperature higher than __________.
- 2012.According to Coast Guard Regulations (46 CFR), the piping, valves, and fittings for a fixed CO2 fire extinguishing system shall have a bursting pressure of not less than __________.
- 2013.According to 46 CFR Part 147, a cylinder used for storing CO2 in a fixed firefighting system must be hydrostatically retested and re-stamped every __________.
- 2014.The Pollution Prevention Regulations (33 CFR) requires an emergency means of stopping the flow of oil during oil transfer operations. The emergency means must be operable from the __________.
- 2015.According to 46 CFR Part 32, a cargo pump driven by an internal combustion engine on the weather deck must have __________.
- 2016.A hole in the hull above the waterline may be temporarily patched with __________.
- 2017.Which of the following statements is correct concerning fixed carbon dioxide fire extinguishing systems?
- 2018.According to Coast Guard Regulations (46 CFR), when loading, or discharging oil in bulk at a dock, which of the following signals must be displayed?
- 2019.When a tank vessel with a capacity of 250 barrels is transferring oil to a facility, the Pollution Prevention Regulations (33 CFR), require an emergency means to stopping the flow of oil which must be operable from __________.
- 2020.In an emergency, a hole in the hull below the waterline, not over three inches in diameter, can be temporarily sealed by __________.
- 2021.When a cylinder is used to store CO2 in a fixed firefighting system and is retested in accordance with regulations, all flexible connections between cylinders and distribution piping must be renewed or tested at __________.
- 2022.According to Pollution Prevention Regulations (33 CFR), tank vessels are required to have a means of emergency shutdown. This device __________.
- 2023.Fuel containers used for refueling portable gasoline driven pumps and exceeding a capacity of five gallons, should be stowed __________.
- 2024.It is generally not advisable to drive a wedge into a crack occurring in the hull because wedges __________.
- 2025.Which of the signals listed is required to be displayed during the day while loading fuel?
- 2026.The Pollution Prevention Regulations (33 CFR) requires an emergency means of stopping the flow of oil during oil transfer operations. That emergency means may be a/an__________.
- 2027.The component in an inert gas system used for cleaning the gas of solid and sulphur combustion products, while simultaneously cooling the inert gas, is called the __________.
- 2028.An acceptable method of temporarily sealing a crack formed in the hull of a vessel is to __________.
- 2029.The fire extinguishing action of CO2 comes mostly from __________.
- 2030.The emergency shutdown requirements of Pollution Prevention Regulations (33 CFR Part 155) apply to __________.
- 2031.Which of the following represents an emergency procedure used to stop the oil flow aboard tank vessels, of 250 tons or greater, as required by Pollution Prevention Regulations (33 CFR)?
- 2032.Where will you find the procedures for the reporting of oil discharge into the water?
- 2033.Which of the listed functions is the purpose of a gas scrubber in an inert gas generation system?
- 2034.While your vessel is fueling, you notice that the transfer hose has developed a large bulge. Which of the following actions should be taken, according to Coast Guard Regulations (33 CFR), if you are the person-in-charge?
- 2035.The lengthening of a crack formed in the shell plating of a ship may be prevented by __________.
- 2036.The empty weight of a B-II CO2 fire extinguisher is 34 pounds, therefore, the full charged weight is __________.
- 2037.Portable carbon dioxide fire extinguishers should be sent ashore to be recharged __________.
- 2038.Inert gas systems fitted on tank vessels must be fitted with an alarm to give an audible and visual warning when the oxygen content of the inert gas exceeds __________.
- 2039.Prior to entering a shipboard compartment containing spilled sewage, you should test the atmosphere in the compartment for __________.
- 2040.The empty weight of a '100 pound' cylinder in a fixed CO2 fire extinguishing system is 130 pounds. What is the minimum acceptable weight of the cylinder before recharging would be required?
- 2041.The blowers of an inert gas generation system aboard a tanker, will be automatically secured if __________.
- 2042.When pumping sour crude, which gas should be tested for prior to entering the cargo pump room to repair a leaking pump?
- 2043.On a tanker vessel, what is the required combined capacity of the inert gas generating system as compared to the total capacity of all the cargo pumps which can be operated simultaneously?
- 2044.Waste oil from the lube oil sumps of machinery may NOT be __________.
- 2045.Which of the following methods is used to supply inert gas from a flue gas system to the cargo tanks?
- 2046.The Pollution Prevention Regulations (33 CFR) prohibit draining __________.
- 2047.After allowing for pressure losses, the pressure-volume capacity of an inert gas blower must be able to maintain a pressure, in any cargo tank, with a minimum of __________.
- 2048.The Pollution Prevention Regulations (33 CFR) prohibits draining __________.
- 2049.The Pollution Prevention Regulations (33 CFR) state that a ship's oily bilge slops may be pumped in port only if the __________.
- 2050.According to CFRs, open tank hatches from tanks which are not gas free, and unattended, must be protected by __________.
- 2051.Flame screens used on ullage openings prevent flames from entering a tank by __________.
- 2052.In accordance with Coast Guard Regulations (46 CFR), what quantity of B-II extinguishers would be required in an oil fired boiler space on a 25,000 gross ton cargo vessel in which no sand, soda impregnated sawdust, or other approved dry materials are provided?
- 2053.Following a grounding, you can best determine that a SLACK fuel oil tank has been holed by __________.
- 2054.According to Coast Guard Regulations (46 CFR Part 95.50), how many B-II hand portable fire extinguishers are required in a space containing two 4000 bhp main propulsion diesel engines?
- 2055.According to the Pollution Prevention Regulations, any discharge of oil, or oily mixture into the sea from any oil tanker, or from any ship of 400 gross tons and above, other than an oil tanker, is prohibited while in a ""special"" area. These ""special areas"" are designated in __________.
- 2056.Your vessel has run aground and upon taking fuel oil tank soundings, you find that a fuel tank level has increased. You therefore should suspect __________.
- 2057.According to Coast Guard Regulations (46 CFR), how many 15 pound carbon dioxide fire extinguishers are required to be installed in a machinery space containing an 8,000 horsepower main propulsion diesel engine?
- 2058.According to 46 CFR, a single layer of tank vent flame screen must be composed of corrosion resistant wire and at least a mesh of __________.
- 2059.Coast Guard Regulations (46 CFR) require how many 15 pound carbon dioxide fire extinguishers to be installed in the boiler room of an 8,000 horsepower steam propelled vessel?
- 2060.How many approved B-II fire extinguishers must be carried in the machinery space of a 3000 HP vessel?
- 2061.At the earliest indication of fire aboard your vessel, you must FIRST __________.
- 2062.Coast Guard Regulations (46 CFR) state that the maximum number of type B-II hand portable fire extinguishers required aboard a 299 gross ton uninspected motor vessel with 7000 BHP main propulsion diesel engine is __________.
- 2063.Which of the following statements represents the correct action to take when three crew members discover a fire?
- 2064.According to Coast Guard Regulations (46 CFR), a 299 gross ton 2800 horsepower uninspected motor towing vessel would require __________.
- 2065.A low velocity fog applicator is held in an all-purpose nozzle by a bayonet joint. The applicator is prevented from rotating in the joint by __________.
- 2066.Coast Guard regulations (46 CFR) state that all handheld portable fire extinguishers required aboard uninspected motor vessels shall be type __________.
- 2067.In port, after chemically cleaning a fuel oil tank, you should dispose of the waste oil by __________.
- 2068.Where would you look to find the number of hand portable fire extinguishers required on an uninspected towing or fishing industry vessel?
- 2069.While in dry-dock in a U.S. port, you discover that the spool piece for the fire pump sea suction is wasted away. You should __________.
- 2070.According to Pollution Prevention Regulations (33 CFR), you are required to test cargo discharge piping every __________.
- 2071.According to the Pollution Prevention Regulations (33 CFR), no person may use a connection for oil transfer operations unless it is a bolted or full threaded connection, or __________.
- 2072.Which of the following statements concerning oil transfer, related equipment, tests and inspections is true?
- 2073.According to Pollution Prevention Regulations (33 CFR), a vessel built in 1977 with a gross registered tonnage of 219 tons, must __________.
- 2074.Pollution Prevention Regulations (33 CFR) require a 1500 gross ton vessel (constructed before July 1, 1974) equipped with a fill fitting for which discharge containment is impractical to __________.
- 2075.A vessel over 100 gross tons in coastwise service is to deballast its fuel tanks to a facility while in port. This vessel must have a/an __________.
- 2076.What Coast Guard Regulations apply to the equipment of a fireman's outfit?
- 2077.An ocean going ship of 4000 gross tons must be fitted with a standard discharge shore connection for the discharge of oily wastes to a reception facility. The dimensions for the connection are specified in the Pollution Prevention Regulations under Part
- 2078.Coast Guard Regulations apply to which of the following requirements of the equipment required to be in a fireman's outfit?
- 2079.An ocean going ship of 6000 gross tons or above must be fitted with a standard discharge shore connection with dimensions outlined in Pollution Prevention Regulations (33 CFR) or be substituted with a __________.
- 2080.Which of the following statements represents the Coast Guard Regulations (46 CFR) applicable to the equipment required in a fireman's outfit?
- 2081.According to Pollution Prevention Regulations (33 CFR), the minimum number of bolts permitted in an ANSI standard flange on an oil hose is __________.
- 2082.Pollution Prevention Regulations (33 CFR Part 155) state that no person may transfer oil or fuel to a vessel of 300 gross tons or more, constructed after June 30,1974, unless each fuel tank vent, overflow, and fill pipe is equipped with a/an __________.
- 2083.Which of the following statements represents U.S. Coast Guard regulations concerning the equipment used with firemen's outfits?
- 2084.According to the Coast Guard Pollution Prevention Regulations (33 CFR), what is the minimum number of bolts required in a temporarily connected standard ANSI coupling?
- 2085.The Pollution Prevention Regulations (33 CFR) requires that no person may transfer oil to or from a vessel unless __________.
- 2086.According to CFRs, how many emergency outfits are required to be carried onboard all tankships over 1,000 gross tons?
- 2087.The minimum number of bolts necessary for a standard ANSI oil transfer hose temporary flange coupling (eight bolt hole flange) is __________.
- 2088.Pollution Prevention Regulations (33 CFR Part 156), state that no person may transfer oil to or from a vessel unless __________.
- 2089.As part of the emergency outfit required to be carried onboard all tank vessels over 1000 gross tons, flashlights must be __________.
- 2090.The tanks used for oily waste on a new ocean going cargo ship of 6000 gross tons must meet certain requirements for isolation between oil and bilge systems. These requirements are set forth in __________.
- 2091.A fireman's outfit carried onboard cargo vessels, must have a __________.
- 2092.U.S. Coast Guard Regulations (33 CFR), state that ocean going ships of 400 gross tons and above must be fitted with a standard discharge shore connection for the discharge of oily waste from machinery space bilges to reception facilities. The flange of
- 2093.According to the Coast Guard Pollution Prevention Regulations (33 CFR), no person may transfer oil to or from a vessel unless __________.
- 2094.According to 33 CFR's, an oceangoing ship of over 400 gross tons must be fitted with a standard discharge shore connection. What size bolt circle diameter is required for this shore connection to transfer oily ballast to a shoreside reception facility?
- 2095.According to Pollution Prevention Regulations (33 CFR), no person may transfer oil to or from a vessel unless __________.
- 2096.Which of the following statements is true concerning oil transfer connections?
- 2097.Oil Pollution Prevention Regulations (33 CFR), require that the person-in-charge of transfer operations is to insure that the __________.
- 2098.In accordance with Coast Guard Regulations (33 CFR), each pressure gage used in fuel transfer operations must be calibrated to indicate pressure within what percent of the actual pressure?
- 2099.The Pollution Prevention Regulations (33 CFR) require that no person may transfer oil to or from a vessel unless __________.
- 2100.While on watch in the engine room, you hear a continuous sounding of the general alarm. Which of the following actions should you take FIRST?