F6 Maintenance and Repair — Operational Level — Page 3
239 questions with correct answers. Click a question to see its answer.
Take the full test →Random exam test generator, free, no registration- 201.Which of the following causes soot deposit and clogging of the nozzle holes of the fuel injector?
- 202.Which of the following does not fit into the distillation process?
- 203.Which of the following dynamic type pumps can achieve a speed ratio of up to 1,000?
- 204.Which of the following failures causes an increase in the deposit and closure of the nozzle openings of the fuel valves:
- 205.Which of the following has the strongest effect on the variation of the maximum pressure:
- 206.Which of the following indicators can be obtained by direct measurement?
- 207.Which of the following indicators characterized the air supply of the engine?
- 208.Which of the following malfunctions can cause engine smoke?
- 209.Which of the following methods of converting seawater to freshwater is most productive?
- 210.Which of the following operations does not form part of the procedure to bring the turbine to a standby?
- 211.Which of the following parameters can be obtained by direct measurement?
- 212.Which of the following parameters changes significantly during the transition from distilled to heavy fuel oil and vice versa:
- 213.Which of the following parts of the centrifugal pump are mostly subject to wear and as a rule are changed at every scheduled maintenance?
- 214.Which of the following principles applies to the transfer of heat into Ship Steam Boilers?
- 215.Which of the following pumps can be damaged if the discharge valve is closed before the motor is stopped?
- 216.Which of the following reasons causes a decrease in the elasticity of the piston rings?
- 217.Which of the following statements is not true regarding to the free-surface effects of liquid cargo on the stability of the ship?
- 218.Which of the following statements is not true regarding the advantages of worm gears?
- 219.Which of the following steam boilers has the highest boiler water quality requirements?
- 220.Which of the listed below is the most probable cause for starting fire in the air heater?
- 221.Which of the oil system types has the lowest reliability in terms of bearing unit performance?
- 222.Which of the turbine preheat methods is prioritized for ship steam turbines?
- 223.Which of these is the main method for marine turbine pre-heating?
- 224.Which oil temperature it is called "critical"
- 225.Which parameter is critical when finalizing the turbine heating?
- 226.Which parameter taken from the fuel diagram indicates the state of the openings of the nozzles while the engine is running?
- 227.Which statement about the procedure for the boiler water analysis is incorrect?
- 228.Which statement is true regarding the oil wedge?
- 229.Which waterproof compartment ìs not equipped with a measuring pipeline?
- 230.Why do many engine manufacturers recommend that the sealing surfaces of the valve and the seat have a half degree difference in the exhaust and intake valves?
- 231.Why is it necessary to turn the engine before starting (turning the engine by compressed air)?
- 232.Why it is necessary to ensure during assembling of the plate type heat exchanger that the connections are tightened to position "A"
- 233.Why must the purge valve be open during starting of the air compressor?
- 234.Will the rotation speed of a running asynchronous motor with a wound rotor change if its impedance in the rotor circuit is increased?
- 235.Witch an advantage of the steam air heater makes them applicable in ship’s steam plant?
- 236.With a constant brake-specific fuel consumption, which of the following indicators increases most when increasing the rpm?
- 237.With O-rings on the cylinder liner of a water-cooled air compressor, where is water most likely to appear when the compressor is started?
- 238.With which device the insulation resistance of the ship's electrical equipment can be measured?
- 239.Мost of the engine manufacturers recommend replacing the seals between cylinder liner and cylinder head every time during piston overhaul. Why?