SeaQuiz

The vessel has its propulsion machinery located amidships, using a water lubricated stern tube bearing, to carry a tail shaft of a 15 inch (38.1 cm) diameter. During the inspection the wear between the stern tube and the bearing surface was measured as 1/4 inch (.635 cm). Which of the following actions should be carried out as a result of this measurement?

  1. APull tailshaft and replace the bronze liner.
  2. BPull tailshaft and replace the lignum vitae.
  3. CPull tailshaft and buildup the bronze liner.
  4. DNothing, as the reading is within the allowable limits. ✓

Correct answer: D) Nothing, as the reading is within the allowable limits.

USCG question bank (2008) · Engineering General Subjects – Question Bank Book 11 · pass mark 70%

← PreviousNext →
Take the full practice test: Engineering General Subjects – Question Bank Book 11 →Free USCG practice test with the real pass mark, no sign-up

More questions from this module

Question list: Engineering General Subjects – Question Bank Book 11 (BK11)