SeaQuiz

While reaming a hole, the reamer should not be turned backwards if the hole has not been fully reamed because __________.

  1. Athe cutting edges may be damaged ✓
  2. Bturning in the wrong direction will cause chatter
  3. Cthe shank will loosen in the tap wrench
  4. Dreverse rotation will make the hole oversize

Correct answer: A) the cutting edges may be damaged

USCG question bank (2008) · Engineering General Subjects – Question Bank Book 11 · pass mark 70%

← PreviousNext →
Take the full practice test: Engineering General Subjects – Question Bank Book 11 →Free USCG practice test with the real pass mark, no sign-up

More questions from this module

Question list: Engineering General Subjects – Question Bank Book 11 (BK11)