F2 Cargo Handling — Management Level — Page 3
493 questions with correct answers. Click a question to see its answer.
Take the full test →Random exam test generator, free, no registration- 201.By the term "deratization" means the operation for
- 202."Cargo Securing Manual" is required for
- 203.The content of the text - Marking of cargo (Standard shipping mark) is object of
- 204.Instruments for measuring oxygen content in the air and the concentration of toxic or flammable gases are required in
- 205.Will you take the fuel and you are responsible for the preliminary preparation of the ship for the adoption of the bunker. Which of the following, do you consider the most important, before the start of the bunkering?
- 206."ANGLE OF REPOSE" is characteristic of
- 207."ANGLE OF REPOSE" means
- 208."STOWAGE FACTOR" means
- 209.Centre of Buoyancy (B) is the
- 210.Inclining Experiment is done in order to
- 211.In a river cargo port limit water line is defined by the Convention on load lines in force, respecting the
- 212.The influence of free surface on stability is determined by the ratio between the sum of the moments of free surfaces and
- 213.The second correction for trim, during draft survey, popular as Nemoto correction is
- 214.The deformation of the ship's hull called Sagging under Draught Survey means
- 215.What it leads excessive large transverse metacentric height?
- 216.A single moment changing transverse metacentric height with 1 cm
- 217.For non-hazardous slamming loads the fore draught must be
- 218.For determining of static angle of heel, when checking the stowage plan for grain in bulk, greater precision would have
- 219.Does water displacement (Δ) depend from the density of sea water?
- 220.Which ships should have "Stability information"?
- 221.Which factor has a major impact on the size of the correction of GM for free surfaces?
- 222.Oh what depends the size of the "dead load" (the Ship ' s constant)?
- 223.In determining the quantity of cargo by the ship's draught, the first correction for trim reflects the fact that
- 224.When planning cargo operations, in conjunction with the stability and strength of the vessel, the captain is governed by
- 225.In cargo operations with shipboard cranes ship without visible reasons big heel gets to the pier. This may be a sign of
- 226.The first correction for trim at draft survey is
- 227.The term "Hogging" on Draught survey means
- 228.The line running across the circle of Plimsol, means summer load line to the
- 229.To enable the master to prevent excessive stresses in the ship's structure, the ship shall be provided with a "Loading manual" as required by
- 230."Cargo securing manual" is required
- 231.Cargo Securing Manual must be approved by the
- 232.Under the code of the IMO for securing of cargo (CSS Code) "Maximum Safe Load" MSL "-and Calculated Strength"- CS are in ratio
- 233.Under the code of the IMO IMO for securing of cargo (CSS Code) -Rule of-thumb method requires horizontal securing facilities to withstand the "maximum safe load"- MSL
- 234.The maximum height, 1/3 width of the ship, on a wooden load on deck refers to the
- 235.For the transport of timber on deck at the end of the voyage ships stability
- 236.In respect of the carriage of timber deck of the ship, non-technical metacentric height must be at least
- 237.FOR THE TRANSPORT OF TIMBER ON THE DECK WITH A SPECIALIZED SHIP METACENTRIC HEIGHT ON DEPARTURE SHOULD BE BE AT LEAST
- 238.When the load timber deck, stanchions are required
- 239.If there are no other instructions from the captain, co-captain duty shall enter observations of damage of cargo in
- 240.In preparation, for unloading the ship, should be checked
- 241.By the term "deodorization" means the operation by
- 242.The term "Broken Stowage" means
- 243.The term "sift or may give off dust" means that the cargo is
- 244.Ventilation of the cargo in the holds is performed when the dew point of the ambient air
- 245.Non hygroscopic cargo is moving from cold to warm climates by ship. You have to
- 246.All ship loading devices must be checked and the results recorded in the cargo gear record book at intervals of
- 247.Tests of the ship's cargo loading devices are carried out through suspension, lift and roll-over, with a load equal to the
- 248.What is the meaning of "SWL"?
- 249.By the term "fumigation" means the operation by
- 250.According to the recommendations of the IMO in case of fumigation of cargo at the time of transition (in transit) safety procedures are performed
- 251.What to use explosimeter?
- 252.The abbreviation "ASTM Tables" refers to
- 253.The distance from the surface of the liquid cargo to the deck is called
- 254.By the term "degassing" means the operation by
- 255.With increasing temperature the volume of combustible and explosive liquids
- 256.Ullage is measured from the surface of the liquid to the
- 257.The purpose of the "Inert-gas system on board the tanker
- 258."Too lean" atmosphere of the tank means that the content of
- 259.You are responsible for the discharge and washing of crude oil on the oil tanker. How much is the maximum allowable oxygen content of 1 meter below deck in tanks during the washing of crude oil?
- 260.You are responsible for the loading of the tanker product carrier fitted with segregated ballast tanks (SBT). How can you find out if the load and ballast systems there's a connection?
- 261.You are an officer responsible for the unloading of oil tanker with 15000 tonnes displacement in Corpus Christi, USA. Where should I put the procedure for petroleum operations (Oil Transfer Procedure)?
- 262.You are an officer responsible for the loading of oil tanker in Ras Tannurah. The observer report on deck for a large amount of oil in the water. What you need to do as a priority?
- 263.For what to use the oxygen analyzer?
- 264.What does "decanting line" between sedimentary tanks when cargo tanks are washed with water?
- 265.What does "part flow display system" installed on some oil tankers.
- 266.Why are not allowed to load a tank more than 98% of its capacity.
- 267.Inert gas systems must be able to produce inert gas with content of O2
- 268.Inert gas must be delivered with the oxygen concentration of less than
- 269.You want to use sedimentary tank washer with source of crude oil. Which of the following actions must be done before you start?
- 270.What is the purpose of "small diameter line" of crude oil tanker?
- 271.What is the minimum pressure given in the pipes system for cleaning by crude oil?
- 272.What is the advantage of using inert gas system of an oil tanker?
- 273.What the minimum equipment necessary to get into the tank or an enclosed space that is not gas free or does not contain enough oxygen?
- 274.What it is not necessary to include the Procedure for Oil Operations.
- 275.What does "Load On Top" mean?
- 276.What does "to take the ullage" mean?
- 277.What must be done before entering the pump compartment?
- 278.What should be borne in mind in respect of the contents of gases and oxygen before entering the compartment of the inert gas system?
- 279.As part of the preparation for the adoption of the fuel, you need to drain the oil fuel overflow tank before the beginning of bunkering. Why?
- 280.Oxygen indicator is used to determine whether
- 281.When you need to test the system for COW?
- 282.When we measure "ullages", what do we do?
- 283.When you are connected to the barge and are ready to start bunkering, who gave the order to start the pumps?
- 284.What pressure should be marked cargo hoses?
- 285.Who is responsible for the testing and certification of all cargo hoses?
- 286.Which of the following manuals you'll use to find the number of persons to take part in the loading of leaded petrol?
- 287.This of the following factors will not affect the time required for the separation of oil on the surface of the water in the sediment tank.
- 288.What is maximum allowable content of oxygen in the inert gas fed into a tank of crude oil washed?
- 289.How much is the maximum allowable oxygen content in the middle of the ullage space in the tank during the washing of crude oil?
- 290.What is maximum allowable content of oxygen in the tank during the washing of crude oil?
- 291.How much is the largest allowed back-pressure for Cargo Pump, when being tested?
- 292.Concentration of O2 in the cargo tanks, after inerting, is considered safe if it is
- 293.Which of these options is recommended when "decanting over board the water from slop tank"?
- 294.Which of the following forms, or documents are not required for tanker's operations?
- 295.What precaution should not be adhered to upon completion of loading (topping off)?
- 296.Where can you find the number of persons who should participate in the oil operations?
- 297.What level of slop-system high level alarm gives signal?
- 298.The time interval must be certified cargo hoses?
- 299.The tanker without inert gas system, what is the atmosphere in the tank during washing?
- 300.The tanker with inert gas system, what is the atmosphere in the tank during washing?