SeaQuiz

What precaution should be taken during fault detection measurements with a simple solenoid type mechanical voltmeter?

  1. ANever use for/at frequencies greater than 60 Hz, as then the unit may not detect dangerous voltages. ✓
  2. BAlways remember that this meter is polarity sensitive and in DC circuit measurements reversal of directions may lead to heating inside the device.
  3. CNever to be connected where potentials greater than 120 volts would occur, as a very thinly wound coil would not withstand more than a few amps.
  4. DAlways switch to the next higher range than the measured voltage to protect the unit from damage.

Correct answer: A) Never use for/at frequencies greater than 60 Hz, as then the unit may not detect dangerous voltages.

← PreviousNext →
Take the full test: F5 Electrical Engineering — Management Level →Random exam test generator, free, no registration

More questions from this test

Question list: F5 Electrical Engineering — Management Level