F2 Maintenance and repair — ETO (CMKE, Poland) — Page 3
326 questions with correct answers. Click a question to see its answer.
Take the full test →Random exam test generator, free, no registration- 201.For proper battery operation, recharge unused batteries:
- 202.The alkaline batteries are often additionally protected from:
- 203.In a ship's network insulated with the correct isolation resistance, the electric shock current at contact with one of the phases is caused by:
- 204.The most important condition for taking emergency action in case of an electric shock is:
- 205.To restore heart action after an electric shock, the heart massage should be performed at a frequency of approx.:
- 206.Electrical work which does not need to be carried out by an accompanying person are as follows:
- 207.When the ship’s centre of gravity is located closer to the stern than the centre of buoyancy indicated by hydrostatic curves for the given average draught, then the ship:
- 208.If a vertical coordinate of the ship’s centre of gravity increases, the righting lever of the vessel for various angles of heel:
- 209.Movement of liquid in a tank during vessel heeling causes the increase of:
- 210.Transverse centre of buoyancy and metacentre point are in line with the action of the buoyant force:
- 211.Elevation of the transverse metacentre above the keel depends mainly on:
- 212.What will be result of removal of TEU from the board?
- 213.Unit trimming moment is a moment that will cause:
- 214.It is assumed that the centre of balance of a shipping container lifted with a heavy boom is located:
- 215.A geometric centre of a submerged vessel hull part is the:
- 216.The righting arm of the vessel is calculated as follows:
- 217.Hatch covers that close the loading hatches shall be compliant with the following requirements of:
- 218.Stern door shall be compliant with the following requirements of:
- 219.Branching ballast system is characterised by the fact that:
- 220.Sacrificial anodes installed in ballast tanks, heat exchangers or outside the ship below the water line are means of:
- 221.Regulations by classification institutions require inspections of a submerged hull part of passenger vehicles at least once every:
- 222.Cycloidal propellers are characterised by the fact that:
- 223.Vessel propellers with a uniform pitch:
- 224.The main control machine shall be able to move the rudder to the angle up to:
- 225.Vessel steerage is:
- 226.After distribution of the hydrodynamic force acting on the rudder blade to two components, parallel and transverse to the vessel travel direction, we get:
- 227.Ventilation ducts leading to rooms located below deck of a freeboard or to closed superstructures and deckhouses must be equipped with coamings with the following heights:
- 228.The figure below presents:
- 229.The figure shows a view from above of the inner bottom (from the side of the hold). Select a sentence which is true:
- 230.The figure presents a section of a double bottom. Select the sentence which is true:
- 231.The figure presents a section of a double bottom. Select the sentence which is true:
- 232.Location of a collision bulkhead in vessels is regulated by the provisions of:
- 233.The figure below presents a transverse cross-section through the main deck. Stringer plate thickness equals (in mm):
- 234.International Load Line Certificate is issued by:
- 235.Gross and net registered tonnages included in the vessel’s tonnage certificate are a basis for:
- 236.The figure below presents:
- 237.The figure below presents:
- 238.The figure below presents:
- 239.In afterpeaks with mixed framing, the most often framing type is:
- 240.Which ship length, reinforced by additional structural elements, is considered the nose part of the vessel:
- 241.Shearing forces and bending moments are controlled usually:
- 242.Gate gantry cranes are used:
- 243.A boom crane is:
- 244.On-board boom crane side sill is:
- 245.The line that lifts a load is called:
- 246.SWL marking on a crane means:
- 247.Supply of boom cranes with hydraulic actuation takes place via:
- 248.The most common means to supply on-board equipment is:
- 249.Gantries are a kind of lifting equipment:
- 250.The device used to disable engine movement of a relevant actuation mechanism when the mechanism reaches the limit position is:
- 251.Lifting force moment limiter is used:
- 252.Ro-ro vessels accept loads using:
- 253.Neutral gas generator systems are used:
- 254.Neutral gas shall be characterised by a low content of:
- 255.On tankers, a manifold is used as:
- 256.Cargo pump drives in a tanker with a pump room are located:
- 257.Remote control of cargo valves in a tanker takes place:
- 258.In order to measure the level of cargo tanks for transporting liquid sulphur or asphalt, the following is used:
- 259.The medium flow regulation type in a hydraulic assembly (fig. 1.) is:
- 260.Medium flow regulation type in a hydraulic assembly (fig. 2.) is:
- 261.Sliding hold hatches operate in the following manner:
- 262.An engine of an anchor windlass shall ensure that the anchor chain is hauled in accordance with the current regulations of the Classification Society:
- 263.Starting an AC supplied mooring winch is carried out:
- 264.Automatic mooring devices:
- 265.Mooring mechanisms should be equipped with:
- 266.Figure 3 presents:
- 267.A mooring head in a mooring and anchor winch:
- 268.Figure 4 presents the following type of hatch cover:
- 269.AC squirrel-cage rotors for anchor windlasses, after 30 minutes of operation at rated load shall be able to withstand a standstill in a braked state at rated voltage for no less than:
- 270.AC squirrel-cage rotors for mooring winch drives, after 30 minutes of operation at rated load shall be able to withstand a standstill in a braked state at rated voltage for no less than:
- 271.If a winch is used for anchor and for mooring, the gear speeds intended for mooring which are not adjusted to raising the anchor should have:
- 272.According to the SOLAS Convention, gyrocompasses should be featured:
- 273.A gyrocompass should be activated:
- 274.The alarm system of a gyrocompass with the gyrosphere immersed in electrolyte becomes activated when:
- 275.What ships, according to the requirements of the SOLAS convention, should feature a log?
- 276.What physical phenomenon is used to measure the ship’s speed in Doppler hydroacoustic logs?
- 277.An adaptive autopilot is a device formed on the basis of:
- 278.Automatic Identification System is:
- 279.A TMC/THD (TMC – Transmitting Magnetic Compass System, THD – Transmitting Heading Device) system functions based on:
- 280.Changing the operating frequency of an echo sounder from 50 kHz to 200 kHz:
- 281.An echo sounder converter may be placed:
- 282.Increasing the chart speed of an echogram will:
- 283.The navigation parameter measured in GPS is:
- 284.In a three-dimensional space, the navigation parameter measured in GPS forms:
- 285.Setting the navigation parameter in GPS is done by means of:
- 286.The GPS navigation parameter is pseudo-distance because:
- 287.Ionospheric delay in dual-frequency receivers:
- 288.The nominal GPS constellation is:
- 289.Differential versions of satellite navigation systems take advantage of:
- 290.A position line:
- 291.A ship’s true course is:
- 292.A course over ground is:
- 293.A nautical mile:
- 294.Propagation corrections set in DGPS:
- 295.The reference stations commonly available in marine navigation transmit differential corrections:
- 296.The European Geostationary Navigation Overlay Service (EGNOS) augmenting the transmission of differential corrections:
- 297.DGPS does not eliminate errors caused by:
- 298.The maximum free-space radar range:
- 299.If we reduce the radar cross section of a target 16 times, the maximum free-space radar range:
- 300.What is the distance from a target to a signal transmitter if the target echoes the sent signal back to the source after 10 µs?